User Guide
18
Power cable from
operator (master) arm
SWITCH
STALL FORCE
M
I
N
M
A
X
MASTER INPUTS
GRN
WHT
BLUE
BRN
ORG
RED
BLK
GRN
BLK
RED
RECEIVER
COM COM
CYCLE
CLOSE
SAFETY
EXI
T
OPEN
SHADOW
LOOP
CLOSE
EDGE
OPEN
EDGE
J11
J8J5J13
J12
Step 2
Strip approximately
3
/16" of insulation from each wire of the operator
power cable. Twist each exposed wire tightly (there are seven [7] wires
inside the power cable sheath). Loosen sealing nut on strain relief hub at
bottom of control box. Insert power cable into control box through strain
relief. Thread approximately 6" of the power cable into the control box and
retighten sealing nut until the power cable locks into place.
Step 3
Insert the stripped operator power cable wires into the
appropriate terminals on the OPERATOR terminal block.
The green wire should be inserted into the GRN terminal, the
blue wire into BLU, the orange wire into ORG, black wire
into BLK, and the red wire into the RED terminal.
Tighten the set screws against the end of the wires. A dab of
petroleum jelly on each terminal will help prevent corrosion.
Do not overtighten.
Connecting Operator Power Cable
Operator Power Cable
Strain Relief
1
ON
2 3 4 5 6 7
1
ON
2 3 4
15
18VAC RECEIVER
BAT
+
SWITCH
FUSE
ALARM
SWITCH
DUAL
MODE
S
SET
LIMI
T
LEARN
TRANSMITTE
R
MODE
S
ON
OF
F
ON
OF
F
1 2 3 4 5 6 7
1 2 3 4
BA
T
–
SOLAR RELAY OUT SLAVE INPUTS
GRN WHT BLUE BRN ORG RED BLKNC RLY-COM NO
MASTER INPUTS
GRN WHT BLUE BRN ORG RED BLK COM COM
CYCLE
CLOS
E
SAFET
Y
EXIT
/
OPEN
SHADOW
LOOP
CLOS
E
EDGE
OPEN
EDGE
BLKGRN RED
+–~~
12'
10'
8'
14'
16'
GATE LENGTH
800-543-GATE
www.gtoinc.com
GTO, Inc.
3121 Hartsfield Rd
Tallahassee, FL 32303
Correct
Wrong Wrong
Wire
Terminal
Block
Terminal
Block
Terminal
Block
Wire
Wire
Installing the Battery
Step 4
Make sure the control box power switch is in the OFF position. The ON/OFF Switch
is located on the bottom of the control box. Remove the control box cover and slide
the battery into position with its terminals to the RIGHT (see illustration). Connect
the BLACK battery wire to the NEGATIVE (–) battery terminal. Connect the RED
battery wire to the POSITIVE (+) terminal. Pay close attention to the color of the
wires. If the wires are connected incorrectly, the control board may be damaged.
NEVER insert the battery with the terminals to the left.
RED wire to POSITIVE (+) terminal
BLACK wire to NEGATIVE (—) terminal
RED
BLACK
Sealing Nut
Hub
Lock Nut
Strain Relief
NOTE: The battery that came with your GTO/PRO® 4000,
MUST be placed horizontally battery with the terminals on the
RIGHT. If an optional second battery is needed, both batteries
must be placed vertically with terminals at the bottom. An
optional second battery can be used for solar and/or high traffic
applications, if needed.
Single Battery
Installed Horizontally
with terminals on the right.
Dual Batteries
Installed Vertically
with terminals on bottom.