User Guide

25
2. Set the transmitter DIP Switches
There are nine (9) transmitter DIP switches; each can be placed in three different
positions (+, 0, –). DO NOT set all the switches in the same position, such as all +, all
0, or all –. Once the DIP switches have been set to a personal code, replace and close
the access cover.
WARNING: No other adjustments should be made inside the transmitter.
Setting Your Personal Transmitter Code
1. Remove the Transmitter Cover
Grasp the sides of the access cover and slide it away from the transmitter button (see
illustration). When the access cover is removed, the battery and the DIP switches will be
exposed. To set a new code, use a small screwdriver to move the switches.
All GTO transmitters are set to a standard code at the factory and are ready to operate your GTO/PRO® 3000 Gate
Operator
®
. For your safety and security, however, we strongly recommend that you replace the factory setting with your
own personal code. Follow the directions below:
3. “Teach” the New Code to Control Board Memory
1
ON
234567
SET
LIMIT
LEARN
TRANSMITTER
MODES
ON
OFF
1 2 3 4 5 6 7
Learn Transmitter Button
STALL FORCE
M
I
N
M
A
X
GRN BLK RED
RECEIVER
COM COM
CYCLE
CLOSE
SAFETY
EXIT
OPEN
SHADOW
LOOP
CLOSE
EDGE
OPEN
EDGE
J11
J8
J12
A. Press and hold transmitter button.
B. Press and hold the LEARN TRANSMITTER
button on the control board for 5 seconds.
C. Release transmitter button.
D. Release LEARN TRANSMITTER button.
The new code is stored in control board memory.
,
I
n
c
.
, In
c
.
, Inc.