User Guide

32
Step 3
With the gate in the desired open position PRESS & HOLD the “SET LIMIT" button on the control board for 5 seconds.
Step 4
Press the transmitter button and allow the gate to return
to the closed position. YOUR GATE’S OPEN POSITION
LIMIT IS NOW PROGRAMMED.
TESTING YOUR OPEN LIMIT SETTING:
Press your entry transmitter and allow your gate to open.
If the OPEN position is not correct or need to be changed,
you will need to CLEAR your OPEN LIMIT settings and
follow steps one (1) to four (4) again.
CLEARING PROGRAMMED OPEN LIMIT
SETTING:
If you make a mistake and set the limit at the wrong
position – press your transmitter to return the gate to the
fully closed position, then press and hold the "SET LIMIT"
button for 10 seconds. This will clear the memory for the
open limit position. Follow steps one (1) to four (4) again.
1
ON
2 3 4 5 6 7
RECEIVER
SET
LIMIT
LEARN
TRANSMIT
TER
MODES
ON
OFF
1 2 3 4 5 6 7
COM
CYCLE
CLOSE
SAFETY
EXIT/
OPEN
SHADOW
LOOP
CLOSE
EDGE
OPEN
EDGE
BLKGRN RED
Set Limit Button
STALL FORCE
M
I
N
M
A
X