User Guide
29
1
ON
2 3 4
15
CHARGING
POWER
STATUS
RF
PULL-PUSH
MODE1
MODE
2
LOCK/BEACON
OFF 120
MIN MAX
STALL FORCE
CLOSE TIME
SET
LIMI
T
LEARN
REMOTE
AU
X OUT
SOLAR
PANEL
18VAC
RCVR
GRN
BLK
RED
EXIT
SAFETY
EDGE
CYCL
E
COMMON
LINK
Wires from Non-Contact Sensor
Refer to the sensor manufacturer’s instructions for information
about installing these devices on a vehicular gate.
Make sure the power switch to the operator is
turned off before connecting safety device wiring
to the terminal blocks. Unplugging the transformer
does not turn power to the operator OFF.
Non-Contact Sensor Connection:
Connect one of the non-contact sensor dry contact output wires to
the COMMON (COM) terminal and the other to the SAFETY
terminal on the GTO/PRO SW-1500
control board.
This input is ONLY monitored when the gate
is closing. Activating the non-contact sensor
(obstructing the safety beam path) will cause the
gate to reverse to the fully open position.
Non-Contact Sensors (photo beams)
The GTO/PRO SW-1500 can also accept "Safety" input from normally open "dry-contact" output devices such as photo
beams connected to the SAFETY input terminal.
Any safety device that pulls more than 40 mA DC must have its own power supply.
If not installing a non-contact sensor skip to next section.
PLEASE NOTE: Non-contact sensors are not included with the GTO/PRO SW-1500.
Exit Loop
If not installing an exit loop skip to next section.
Refer to the sensor manufacturer’s instructions for information
about installing these devices on a vehicular gate.
Make sure the power switch to the operator is
turned OFF before connecting safety device
wiring to the terminal blocks. Unplugging the
transformer does not turn power to the operator
OFF.
Free Exit Connection:
Connect one of the free exit wires to the COMMON
terminal and the other to the EXIT terminal on the GTO/
PRO SW-1500 control board.
A FREE EXIT device or loop that senses a vehicle as
it approaches the gate from inside the property and
automatically opens the gate to allow the vehicle to exit.
PLEASE NOTE: Non-contact sensors are not included with the GTO/PRO SW-1500.
1
ON
2
3 4
15
CHARGING
POWER
STATUS
RF
PULL-PUSH
MODE1
MODE2
LOCK/BEACON
OFF 120
MIN MAX
STALL FORCE
CLOSE TIME
SET
LIMIT
LEARN
REMOTE
AUX OUT
SOLAR
PA
NEL
18VAC
RCVR
GRN
BLK
RED
EXIT
SAFETY
EDGE
CYCLE
COMMON
LINK
Wires from Exit Loop or Device