User Guide

9
Tools Needed
• Power Drill
• Open End Wrenches —
3
/8",
7
/16",
1
/2", and
9
/16"
•
3
/8" Drill Bit
• Hacksaw or Heavy Duty Bolt Cutters
• Small (Flat Bladed) Screwdriver
• Phillips Screwdriver/ Large
• Tape Measure
• Level
• Wire Strippers
• C-Clamps — small, medium, and large
• Center Punch
• Extra person will be helpful
YOU MAY ALSO NEED THESE ITEMS BEFORE YOU BEGIN THE INSTALLATION
(Some of these items can be found in the
Accessory Catalog page 37):
• Low voltage wire (RB509) will be needed to run from the transformer to the operator control board; length depends
upon the distance between the transformer power supply and the operator arm. See Powering the System
on page
18, and the Accessory Catalog.
• If your gate is more than 1000' away from an AC power source you will need to use at least one GTO/PRO® 5 watt
Solar Panel (FM122) to charge the 12 Volt automotive or marine type battery (not included). See the
Accessory
Catalog
.
• If your fence post is made of wood and is less than 6" in diameter or 6" square, see page 12.
• If your fence post is larger than 6" in diameter you will need threaded rods or carriage bolts longer than 8". See
page 15.
• Metal plate or washer. See page 12.
• PVC conduit.
• If you have thin walled tube or panel gates, see
Recommended Reinforcement Examples on page 12.
• Depending on the type of gate, a horizontal cross member or mounting plate may be needed to mount the front
of the operator and gate bracket to the gate. See page 11, step 2; page 15, step 10.
• Surge protection for transformer.
• Some types of installations require U-Bolts.
• 12 rde deep cycle marine battery.
• Weather-proof cover for the marine battery
• Spade tongue terminal. See page 21, step 8.