User Guide
4
1
ON
2 3
4
15
CHARGING
POWER
STATUS
RF
PULL-PUSH
MODE
1
MODE
2
LOCK/BEACON
OFF 120
MIN MAX
STALL FORCE
CLOSE TIME
SET
LIMI
T
LEARN
REMOTE
AU
X OUT
SOLAR
PANEL
18VAC
RCVR
GRN
BLK
RED
EXIT
SAFETY
EDGE
CYCLE
COMMON
LINK
1
ON
2 3 4
PULL-PUSH
MODE1
MODE2
LOCK/BEACON
Setting SECOND arm to operate as SLAVE arm:
1. The SLAVE arm should be at the fully retracted position at this time.
Setting the CLOSE LIMIT (Pull to open installation only):
1. DIP switch #1 should be in the OFF position.
2. Turn the ON/OFF switch to the ON position on the master arm.
3. Turn the ON/OFF switch to the ON position on the slave arm.
4. Wait 15-20 seconds for the receiver to ‘warm-up’.
5. Press the remote (assuming that the remote has already been ‘learned’). The SLAVE arm or both
arms (depending on your sequence setting) should be closing.
6. Press the remote again to stop the gate at the desire closed position. Note: whichever gate reached
its desired closed position first that will be the first one to be programmed.
If the SLAVE arm is stopped at the desired closed position, press the ‘SET LIMIT’ on the
SLAVE arm for 5 seconds.
If the MASTER arm is stopped at the desired closed position, press the ‘SET LIMIT’ on the
MASTER arm for 5 seconds.
Press the remote again and allow both gates to return to the fully opened positions.
7. Repeat step 5 for the side that has not been programmed in the previous step.
ON/OFF
6
5
Gate Operator in the
RERACTED POSITION
2. The receiver should be disconnected from the slave arm. The re-
ceiver is not operational if the arm is operating in SLAVE mode.
3. DIP switch #1 has no function in SLAVE mode.
4. Set DIP switch #2 and #3 (MODE 1 and MODE 2) to the ‘OFF’ position
(factory default). This setting will set the arm to operate in SLAVE mode if
there is a MASTER arm present.
5. DIP switch #4: (See main manual for additional details)
OFF: Pulse output at ‘AUX OUT’ terminal when gate is opening.
ON: Continuous output at ‘AUX OUT’ terminal when gate is moving.
O
N
/
O
FF
Disconnect
Receiver Wires