User Guide

3
Step 1: Determine the optimum location for the EXIT WAND using the information found in “Placement of the
WAND” on page 2. Then dig a hole approximately 12 inches deep and 24 inches long within two (2) feet and
parallel to the edge of the driveway. Next, dig a trench from this hole to a spot under the gate operator control box
to run the wire from the WAND to the control box.
Keep the WAND and the cable uncovered at this time.
We recommend that the cable be run in PVC conduit to the control box to prevent damage to the cable from lawn
mowers, weed eaters and grazing animals. Do not run any other type of wire or cable in conduit with WAND
cable.
Step 4: Unscrew and remove the lock nut from the WIRE
CLAMP hub (included with hardware). From the outside of
the control box, insert the WIRE CLAMP hub and sealing
nut (see illustration right) into the new WIRE CLAMP
hole. Finger tighten the lock nut onto the threaded end of the
WIRE CLAMP hub from inside the box.
Installing The WIRE CLAMP: The WIRE CLAMP (includ-
ed) is used to secure the WAND cable where it enters the control box to
prevent it from being accidently pulled out.
Step 2: If you are installing the WAND on a GTO/PRO low voltage
single gate operator, use a screwdriver or steel punch to carefully remove
the thin plastic knockout disk (see illustrations at right) at the bottom
of the control box. If you have a dual gate operator system on a PRO-
SW1000/2000 or PRO-SL1000/2000 system or are installing the WAND
on a GTO/PRO AC powered operator, drill a 7/8” diameter hole at the
bottom of the control box and install the WIRE CLAMP. On non-GTO
operators, see page 10 of this manual, as well as, consult the manufactur-
ers intallation maunal.
Be careful with tools to avoid contact or damage to the control
board!
Step 3: Use a sharp knife or deburring tool to clean the rough edges from
the hole.
Sealing Nut
Hub
Lock Nut
Wire Clam
p
Determining WAND Location:
Installing the EXIT WAND ...
Gate operator
control box
Driveway
Minimum of 25 feet
RANGE:12 foot radius (max)
WAND: 2 feet from driveway
edge and 1 foot in ground
Open gate outside
wand range
PVC conduit in ground and
up to control box recommended
WIRE CLAMP for
Opener Power Cord
PRO-SW3000 & PRO-SW4000
Control Box
O
N
/O
F
F
Knockout Disk
Knockout Disk
WIRE CLAMP for
Operator Power Cord
PRO-SW1000/2000 & PRO-SL1000/2000
Control Box
Drill 7/8" Diameter
Hole For Dual Gate
System