User Guide

8 0 0 - 5 4 3 - G AT E ( 4 2 8 3 ) • w w w. m i g h t y m u l e . c o m
Checklist
Answers to commonly asked
questions
1. What is a Mighty Mule E-Z Gate Opener?
A Mighty Mule E-Z Gate is a remote controlled automatic gate
opener system. It is the industry leading gate opener available for the
“Do-It-Yourself” installer. Because it is battery operated and uses
low voltage power, it is safe (no electrician needed), affordable, and
easy to install.
2. How is a Mighty Mule E-Z Gate Opener Powered?
All Mighty Mule gate openers are low voltage systems with a 12
Volt battery back up system. This assures operation of your gate
during a power outage. The battery can either be charged by the
included transformer, OR can be charged by optional solar panel(s).
3. How do I Install the Solar Panels?
The Mighty Mule solar panel (FM121) is a complete kit for easy
mounting within 8 ft. of the control box. If your panel(s) must be
placed farther away than 8 ft. (up to 250 ft.) to receive maximum
sunlight, additional low voltage wiring will be required. It is
important that the solar panels face South and are placed in full
sunlight, away from overhanging trees, or any obstacle that may
shade the panels(s).
4. Will the Mighty Mule Open During A Power Outage?
Yes. A fully charged FM500 or FM502 battery will provide an
average of fifty (50) cycles (open and close) and the FM350 battery
(12 Volt car or marine battery not included) provides up to 1500
cycles during a power outage. This number can vary depending on
factors such as the type of gate, number of accessories added, and
weather conditions if using solar panel(s) (FM121) to charge the
battery.
5. Can I Manually Open the Gate?
Yes! Each opener arm is mounted to the brackets on the post(s) and
gates(s) with clevis pins and clips. By removing the pin and clip at
the front end, the arm can be removed and allow the gate to be
opened manually.
6. What Happens if the Gate Opener Hits Something?
All Mighty Mule E-Z Gate openers have built-in safety obstruction
sensing which will cause the gate(s) to “Stop” and “Reverse” its
direction for two seconds if it comes in contact with an object. If the
gate comes in contact with the object twice before returning to its
fully open or close position, an alarm will sound for 5 minutes.
7. Is the Mighty Mule Gate Opener Difficult to Install?
No. Most installations can be completed easily in two to three hours.
Dual gates will take slightly longer because two operator arms are
required. All installations can be completed with tools commonly
used by most homeowners. Kits include an installation video (see
box for details.)
8. What Maintenance is required?
All Mighty Mule E-Z Gate Openers are designed to be virtually
maintenance free. However, it is recommended that the push-pull
tube be sprayed once a month with a good grade of “silicone” spray.
DO NOT use an oil based spray as this will attract sand and dirt.
Do you have all the tools for the installation?
Did you purchase the proper power supply option?
(low voltage wire or solar)
If your gate swings out from your property did you purchase the
push-to-open bracket(s) (FM148)?
Did you note the 'standard' hardware package – will this suit
your installation (some additional hardware maybe needed)?
If you purchased the digital keypad, did you get 3 AA batteries?
Other Materials You May Need
• Low voltage wire (RB509) (16 gauge, multi- stranded, dual
conductor, direct burial) wire will be needed. Wire length depends
upon which accessories are used and the distance between the
transformer power supply and the gate. [1000 ft. (304 m) max.]
• If your gate is more than 1000 ft. (304 m) away from an AC 110V
power source, Mighty Mule Solar Panels must be used to trickle
charge the battery. The FM350, FM500/700 and FM502/702 are solar
compatible.
• If your gate opens out from your property, you need to purchase or
special order a "push-to-open" bracket (FM148) through your retailer.
Call 1-800-543-1236 for details. You can program the FM350,
FM500/700 and FM502/702 for this application (dual gates require 2
brackets).
• If you have thin walled tube or panel gates, you will need to reinforce
them. See diagrams below for tips on reinforcing these types of gates.
• Depending on the type of gates, a horizontal cross member or
mounting
plate may be needed to mount the opener arm and gate
bracket to the gate.
• Your gate must be in good working order, firmly hung on well seated
fence post, and swing freely and evenly. This operator WILL NOT
WORK on gates with wheels or gates that drag on the ground.
• Gates weighing more than 250 pounds require ball bearing hinges
(not provided by Mighty Mule).
• Gate post greater than 8 inches thick will require longer bolts than
provided to mount gate brackets to post. Gate post thickness plus two
inches.
• Gate post less than 4 inches will require reinforcement hardware;
large metal washers or steel plates for each side of the post.
• Masonry column installation may require special procedures.
Call 1-800-543-1236 (GTO Technical Support) for details.
What else will you need?
Tools You'll Need:
• Power Drill
• Open End Wrenches:
3/8", 7/16", 1/2", and 9/16"
• 3/8" Drill Bit
• Hacksaw or Heavy Duty Bolt Cutters
• Slotted (Flat Bladed) Screwdriver
• Phillips Screwdriver
• Tape Measure
• Level
• Wire Strippers
• C-Clamps — (small,
medium, and large)
Thin Walled
Tube Gate
Steel Pipe Cut in Half
Gate
Bracket
Gate Bracket
Wood or Metal
Reinforcement
Gate
Bracket
Panel Gate
1" x 6"
Wood
Reinforcement
(not supplied)
(not supplied)
(not supplied)
All Mighty Mule E-Z Gate
®
Openers are Certified
and Listed in COMPLIANCE with UL325 SAFETY STANDARDS.
Suggestions for materials you will need
to reinforce your gate: (not in kit or available from GTO)
GTO/PRO
®
, Mighty Mule
®
, E-Z Gate
®
, GTO
®
, are registered trademarks of GTO, Inc. Professional Access
Systems
TM
, America’s DIY Automatic Gate Openers
TM
is a trademark of GTO, Inc. and are the exclusive
property of GTO, Inc. (”GTO”). All rights are reserved by GTO, and these marks may not be used, without
the prior written permission of GTO
®
. Copyright ©2005.
MMISP05
Rev. 6/21/05
L
I
S
T
E
D
USC
1) Do you have a single or dual gate?
2) Does your gate swing or slide?
A) If swing, continue with guide below.
B) If slide, ask your retailer about Special Ordering or call 1-800-543-GATE (4283) for additional information.
3) Does your gate swing into or away from your property?
4) How long is each gate leaf?
5) How much does each gate leaf weigh?
6) Is your gate within 1000 ft. of a 110V AC power source? IF NOT, SOLAR CHARGING IS AN OPTION.
Which Mighty Mule Gate Opener, Is Right For You?
QUESTIONS to consider when purchasing an opener:
OUR OPENERS WORK ONOUR OPENERS WORK ON
ALL TYPES OF GATESALL TYPES OF GATES
GATE TYPE
MAX. GATE
WEIGHT
MAX. GATE
LENGTH
AC POWER
SUPPLY
(within 1000’ of gate)
BATTERY
SOLAR
COMPATIBLE
CYCLES PER
DAY
GATE OPENING
DIRECTION
Opening into or away from property (with add-
itional Push-to-Open brackets - 2 required, FM148)
Opening Gates Around the World Since 1987!
®
®
E-Z GATE OPENER
350350
COMMERCIAL GRADECOMMERCIAL GRADE
COMMERCIAL GRADECOMMERCIAL GRADECOMMERCIAL GRADECOMMERCIAL GRADE
FREEFREE
INSTALLATIONINSTALLATION
VIDEOVIDEO
E-Z GATE OPENER
UL325 SERIES
®
®
350350
COMMERCIAL GRADECOMMERCIAL GRADE
NewNew
20052005
forfor
PLANNING GUIDE
Opening into or away from property (with
additional Push-to-Open bracket, FM148)
175 (with transformer) with 1500 battery
backup cycles
225 (with transformer) with 50 battery
backup cycles
115 (with transformer) with 25 battery
backup cycles
Yes (requires 10 Watt minimum)Yes
INCLUDED
NOT INCLUDED
(12 V automotive/marine style battery required.
18V Heavy-Duty Transformer is included 18V Heavy-Duty Transformer is included 18V Heavy-Duty Transformer is included
INCLUDED
Yes
16 feet
550 lbs.
Single
18 feet
850 lbs.
Single
18 feet (per leaf)
850 lbs. (per leaf)
Dual
Opening into or away from property
(with
additional Push-to-Open bracket, FM148)