User's Manual

6
Intercom Base Unit Installation
Find a convenient location near an approved outlet to
mount or place the intercom. Plug the transformer into
the AC outlet and connect it to the intercom’s power
jack marked DC 9V.
If you are mounting the intercom on the wall, use the
template on the last page of this manual to place screws.
The intercom can be disconnected from the transformer
and used as a battery powered unit. It can be moved to
any convenient location, i.e. bedroom, patio, or garden
area.
IMPORTANT: When the Intercom unit is ON it is in
the receive mode. When plugged into the transformer
it is constantly charging the battery. The battery will
last approximately four (4) hours when unplugged from
the transformer. You can turn the unit OFF to conserve
battery power but it will not receive a signal when OFF.
Remove the battery access cover using a small
phillips head screwdriver. Plug the rechargeable
Ni-MH battery into the receptacle inside the
battery compartment. See diagram to the right.
When this is done, replace the battery access
cover.
Connecting the Battery
Connecting the Transformer
ID SET
Battery Plug
Battery
POWER
Keypad
Batt Low
Grant Permission
Push To Answer/Talk
End Call
DV 9V
Transformer
Approved 110 Vac outlet
IMPORTANT: Once connected, allow the intercom
base unit’s battery to charge for 12 hours before us-

IMPORTANT: Allow the
intercom base unit’s battery
to charge for 12 hours before

time. See page 7 for details.