User's Manual

4 Driveway Alarm
Placing Receiver and Testing System
Receiver Placement
RESET BUTTON
LOW BATTERY LED
TRANSFORMER INPUT
VOLUMN CONTROL
VISITOR LED
POWER LED
• PlacetheindoorRECEIVERinaconvenientlocationthatis
approximately 3 ft. above the floor level.
• PlugtheACtransformerintoa110VACoutletandthe
charger cable into the receiver.
•ThepowerLEDonthefrontpanelwilllightup,andthere
willbeaconrmation“beep”tone.
• WhenacarpassestheSENSOR,asignalistransmitted
totheRECEIVERfromtheTRANSMITTERbymeansofa
433MHzcarrierfrequency.AftertheRECEIVERreceivesthe
signal, the buzzer will “beep” twice, and the visit alert LED
(green) will flash 3 times and remain lit, until the RESET
button is pressed.
• TheLOWBATTERYLEDalertsyouwhenthetwo(2)“AA”
batteriesintheTRANSMITTERneedtobereplaced.
•TesttherangeandsystembyhavingsomeonedriveanautomobilepasttheSENSORtobesurethe
RECEIVERisactivatedwhenthevehiclehaspassedtheSENSOR.Itmaynecessarytoadjustthe
positionoftheTRANSMITTERforoptimumresults.
Testing the System
• WithTRANSMITTERindesiredlocationinstalltwo(2)“AA”batteries.
•TemporarilyplaceTRANSMITTERonthemountingpostinground.
Installing Transmitter Batteries
IMPORTANT: “AA” batteries must be installed at the site where the TRANSMITTER will be located to ensure
proper calibration of the transmitter.
Insert
“AA” Batteries