User's Manual

34 Mighty Mule 202
1 CHGR: Power Input Terminals:
  t *OQVUUFSNJOBMTGPSUSBOTGPSNFSPSTPMBSQBOFM
  t /POQPMBSJUZTFOTJUJWF
2 SAFETY: (Typically for use with photo beam device,
loop detector or other non-contact sensors)
  t "DUJWBUJPOPGUIJTJOQVUXIJMFUIFHBUFJTDMPTJOHXJMMDBVTF
the gate to stop and return to the opened position.
  t "DUJWBUJPOPGUIJTJOQVUXIJMFUIFHBUFJTPQFOJOHIBT
no effect. (gate will continue to open)
  t "DUJWBUJPOPGUIJTJOQVUXIJMFHBUFJTJEMFXJMMQSFWFOUHBUF  
from closing.
  t "DUJWBUJPOPGUIJTJOQVUXIJMFBUPQFOMJNJUXJMMSFTUBSUUIF  
auto close time (if enabled).
3 EXIT: (Typically for use with exit loop or wand)
  t "DUJWBUJPOPGUIJTJOQVUXJMMPQFOUIFHBUFJGJUTOPUBMSFBEZ  
at the open position.
  t "DUJWBUJPOPGUIJTJOQVUXIJMFBUPQFOMJNJUXJMMSFTUBSUUIF  
auto close time (if enabled).
t "DUJWBUJPOPGUIJTJOQVUXIJMFHBUFJTJEMFXJMMQSFWFOUHBUF  
from closing.
4 CYCLE: (Typically for use with doorbell button or hardwired
keypad)
  t &BDIBDUJWBUJPOBUUIJTJOQVUXJMMDZDMFUIFPQFSBUJPO
as follows:
…. OPEN STOP CLOSE STOP OPEN …
5 EDGE: (Typically for use with contact edge sensor)
  t "DUJWBUJPOPGUIJTJOQVUXIJMFHBUFJTNPWJOHXJMMDBVTFJUUP
reverse direction for 2 seconds.
  t "DUJWBUJPOPGUIJTJOQVUXIJMFJEMFXJMMQSFWFOUHBUFGSPNSVOOJOH
6 COM:
  t $PNNPO/FHBUJWFUFSNJOBMGPSBDDFTTPSZEFWJDFT
7 LOCK +: Positive terminal to connect GTO electro-mechanical lock. (FM143)
8 LOCK - : Negative terminal to connect GTO electro-mechanical lock. (FM143)





H
VAR6
PF
K2
K3
K4
REMOVE
PUSH TO
SET
LIMIT
SFTY.
EXIT
CYCLE
EDGE
SENSOR
COMMON
LOCK+
LOCK–
WHT
GRN
RED
BLK
WHT
GRN
SECOND OPR.FIRST OPR.
RED
BLK
14 VAC
OR
SOLAR
ON OFF
1
8
7
6
5
4
3
2
NOTE:
t "MMBDDFTTPSZJOQVUTBSFESZDPOUBDUOPSNBMMZPQFOJOQVUT%0/05BQQMZFYUFSOBMWPMUBHFTPVSDFT
to these inputs.
t "MMBDDFTTPSZJOQVUTBSFDPOOFDUFEXJUISFTQFDUUPCOMMON terminal.
Control Board Connections
LOCK OUTPUTS12 VOLT POWER
CHARGE POWER
INPUTS
ACCESSORY INPUTS
6 COM: Common/Negative terminal for accessory power source.
7 LOCK +: Power source for GTO / Mighty Mule accessories, i.e. Driveway Sensor