User's Manual

Mighty Mule 202 25
Connecting the Transformer
Step 1
Make sure the power switch is OFF before proceeding to
the next step.
IMPORTANT: Use either transformer or solar panel. DO NOT connect both transformer and solar panels to
the opener control board at the same time. It will damage the control board.
ON/OFF
Switch
ON/OFF
Step 2
Select the electrical outlet where you will plug the
transformer. Measure the distance from this outlet to the
control box following the path where the wire will be laid.
After you have measured how much wire is needed, cut the
wire to the appropriate length - up to 500 feet.
Step 3
Lay the measured length of low voltage wire in a trench following a path from the selected electrical outlet to
the control box. Wires coming up from the ground should be run through PVC conduit to protect them from
lawn mower blades, weed eaters, and grazing animals. Be sure to bury the wire laid in the trench.
Gate Opener
Run 500' (max.) of low
voltage wire to control
box from transformer
(wire not included).
120 Volt indoor
Transformer
(surge protector
not supplied)
PVC conduit (not included)
to protect wire from lawn
mowers and weed eaters.
Control Box
12 Volt automotive or marine
type battery in weather proof
housing (not included).
Step 4
Bring enough wire up through the PVC conduit to reach the control box.