User's Manual

12 Mighty Mule 202
1" minimum
Gate in the
OPENED POSITION
Pinch Area
Gate in the
CLOSED POSITION
Pinch Area
1" minimum
13” or less
IMPORTANT: To achieve optimum leverage for the gate opener and ensure long trouble free service, the
gate opener needs to be installed within the following perameters.
The diagram below shows the optium position for gate opener arm in relation to the gate in the open and
close positions.
Installation Overview (continued)
If the gate post is larger
than 6 inches the Post Pivot
Bracket can be removed and
the center hole of the Post
Bracket can be the mounting
point for the gate opener.
NOT RECOMMENDED
FOR GATE POST LARGER
THAN 8 INCHES.
Center hole of
gate opener
pivot bracket
Be sure the position of the gate opener and brackets allows for 1 inch of
clearance between the gate and the opener in both the open and closed
position, at the same time maintaining a maximum distance of 13 inches
from the end of the opener arm to the gate bracket with the gate in the
closed position.