Model number: AR20 OPERATING MANUAL
IMPORTANT SAFEGUARDS: IMPORTANT: READ ALL INSTRUCTIONS BEFORE USE. RETAIN INSTRUCTIONS FOR FUTURE REFERENCE. Do not use in rain or leave outdoors whilst raining. WARNING: Basic safety precautions should always be observed when using an electrical appliance, including the following to reduce the risk of fire, electrical shock, or injury: Personal Safety: • Store indoors in a dry place out of the reach of children. • Always use responsibly.
• Liquid ejected from the battery may cause irritation or burns. • In an emergency situation contact professional help immediately! • Leaks from the battery cells can occur under extreme conditions. Do not touch any liquid that leaks from the battery. If the liquid gets on the skin wash immediately with soap and water. If the liquid gets into the eyes, flush them immediately with clean water for a minimum of 10 minutes and seek medical attention.
Thank you for choosing a Gtech AirRam “I started Gtech to create sensible, easy to use products, which do a great job. Your opinion is important to us. Please take the time to write a review of the AirRam at Trustpilot.co.uk. We will use your feedback to improve our products and services and let other people know what it’s like to be part of the Gtech family.
Assembly Attach the lower handle onto the head of the AirRam. Press the button at the top of the upper handle and slot it into the lower handle until it clicks. Insert the battery by sliding it down. It will click into place. To extend the upper handle, hold down the button on the left hand side and pull it up. It will click into place.
Operation Without pressing the power button, place your foot on the left side of the AirRam head and pull the handle back. Press the button with your foot to turn the AirRam on. 6 The power button is located on the left hand side of the AirRam head.
Storing your AirRam To stow the upper handle, simply press the button on the left hand side and push the handle down. The handle will now be fully retracted and the AirRam can be conveniently stored.
Battery charging When the state of charge indicator starts to flash one green LED, recharge the battery. The battery can be charged whilst it’s in the AirRam, or when it’s off the product. To remove the battery, squeeze the latch underneath and pull upwards. 4 hours Plug the charger in and connect it to the battery. 8 The battery can be charged from flat in 4 hours. The state of charge indicator will show 4 green lights when it is charged. It is OK to charge for 1 hour for a burst of cleaning.
Emptying the bin Holding onto the AirRam with one hand, pull the bin handle and lift the bin out of the AirRam. Release the latch with the green arrow, to pull open the bin lid. Hold the AirRam’s bin over a rubbish bin and push the green lever towards the lid to empty the dirt. Pull the green lever back towards the bottom of the bin. Close the bin lid and reinsert the bin into the AirRam.
Cleaning the filters - do this once a month Holding onto the AirRam with one hand, pull the bin handle and lift the bin out of the AirRam. Pull the filter out of the filter housing. Tap the dirt from the filter and tip any dirt from the filter housing. Wash the filter if necessary. Remove the filter from the inner shroud, by twisting and pulling. Wash the filter under a tap. Squeeze out any excess water then let it dry completely before reinserting into the AirRam.
Replacing the filters Slide the filter onto the inner shroud. Slide the filter and inner shroud into the filter housing. Removing and cleaning the brush bar If the brush bar jams during use, the AirRam will stop and the LEDs will appear red. Before checking for a blockage, remove the battery. Rest the AirRam on its side and locate the brush bar button on the right hand side. Press the button inwards and then pull the brush bar towards the bottom of the AirRam.
The brush bar can now be removed, starting at the button end. To remove hair from the brush bar, run an open pair of scissors down the groove to cut the hair, then pull it out. Re-insert the brush bar, starting by locating the end furthest away from the button. Then push the brush bar into the AirRam until it clicks into place. Replace the battery by sliding it down. It will click into place.
Clearing a jam / fault 10 seconds If the brush bar jams during use, the AirRam will stop and the LEDs will appear red. You will need to remove and clean the brush bar (see page 11). The AirRam will not re-start until the red lights go out. This will take ten seconds. If the problem persists, follow the troubleshooting instructions below. Troubleshooting AirRam is not cleaning well 1. Empty the bin 2. Check bin is correctly fitted 3. Check filter is correctly fitted 4. Clean and/or replace filter 5.
Product Care Your Gtech AirRam doesn’t need much maintenance: keep the filters clean, keep the brush bar tangle-free and charge the battery. Wipe it with a dry cloth if it gets dirty, including under the bin. Never wash it with liquid, run it under a tap or use it without the filter. AIRRAM TECHNICAL SPECIFICATION Battery model Battery Charging period Battery charger output Weight 103A022 22V 2000mAh Li-Ion 4 hours 27V DC 500mA 3.
WARRANTY – TERMS AND CONDITIONS If your Gtech AirRam breaks, don’t worry, we’re here to help. Go to www.gtech.co.uk or call 01905 345 891 for assistance. The warranty on your AirRam is 2 years from date of purchase. WHAT ISN’T COVERED SUMMARY Gtech does not guarantee the repair or replacement of a product as a result of: • The guarantee becomes effective at the date of purchase (or the date of delivery if this is later).
Grey Technology Limited Brindley Road, Warndon, Worcester WR4 9FB CPN0757 email: support@gtech.co.uk telephone: 01905 345891 www.gtech.co.
