Manual

The DrawingBoard VI32 Troubleshooting
To return to the default frequency, repeat the above process. When you
replace the cursor batteries, the cursor is automatically reset to the de-
fault frequency.
Changing the Frequency of the Cordless Pen
Press both side buttons and the tip simultaneously and hold for approxi-
mately three seconds.
To return to the default frequency, repeat the above process. When you
replace the pen batteries, the pen resets to the default frequency.
Changing the Frequency of a Corded Transducer
You must use the Menu Strip to change the frequency of the corded
transducers (see the Setting corded frequency option in the Tablet Op-
tions section).
Tablet Checklist
Is the tablet power supply plugged into the digitizer and into a live
outlet?
Is the tablet power switch On?
Does the Indicator light glow steadily when the transducer is in prox
inside the Active Area? Does the Indicator LED go out when the
transducer is outside the Active Area?
The Indicator light will be off if the transducer has gone into Sleep
Mode. Press any button on the transducer to activate it. If the trans-
ducer is in the Active Area and the Indicator light remains off, change
the transducer’s battery.
Are all cable connections seated properly?
Is the communications cable (either USB or serial) connected to both
the digitizer and the computer? Check that the cable is connected to
the serial port specified in your software package.
Is the transducer cable connected to the digitizer?
Is the tablet set up according to the software recommendations?
Are any of the connector cables or receptacles damaged? Check for
bent pins, cut insulation, and loose wires.