User's Manual

2.402 145 165 175 kHz
2.441 145 165 175 kHz
△f1avg “Maximum Moudulation”
2.480 145 165 175
140<△f1avg <175
kHz
2.402 115 150 - kHz
2.441 115 150 - kHz
△f2maz “Minimum Modulation”
2.480 115 150 -
115
kHz
C/I co-channel - 10 11
<= 11
dB
Adjacent channel selectivity C/I F=F0 +1 MHz
3 5
- -4 0
<= 0
dB
Adjacent channel selectivity C/I F=F0 - 1MHz
3 5
- -4 0
<= 0
dB
Adjacent channel selectivity C/I F=F0 +2 MHz
3 5
- -35 -30
<= - 30
dB
Adjacent channel selectivity C/I F=F0 - 2MHz
3 5
- -21 -20
<= - 20
dB
Adjacent channel selectivity C/I F>=F0 +3 MHz
3 5
- -45 -
<= - 40
dB
Adjacent channel selectivity C/I F<=F0 -5 MHz
3 5
- -45 -
<= - 40
dB
Adjacent channel selectivity C/I F=Fimage
3 5
- -18 -9
<= - 9
dB
Adjacent channel transmit power F=F0±2MHz
4 5
- -35 -20
<= - 20
dBc
Adjacent channel transmit power F=F0±3MHz
4 5
- -45 -40
<= - 40
dBc
Notes:
1
PSR configuration setting maintains the transmit power to be within the Bluetooth specification v2.0 limits
2
Class 2 RF transmit power range, Bluetooth specification v2.0
3
Up to five exceptions are allowed in v2.0 of the Bluetooth specification
4
Up to three exceptions are allowed in v2.0 of the Bluetooth specification
5
Measured at F0 = 2441MHz
FCC Statement:
NOTICE:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications made to this equipment not expressly approved by GT-tronics HK Ltd may void the FCC
authorization to operate this equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Radiofrequency radiation exposure Information:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. Please see the
RF Exposure information. This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
This device should be installed and operated with a minimum distance of 20 cm between the antenna and all persons.
Label requirements:
Contains Transmitter Module FCC ID: B4OBC5MMRPA