Instructions for use

Voltage level: 1.2V/cell
Allowable fast charge current: 1C~2C depends on the
performance of cell discharge voltage cut off level
0.85V/cell(NiCd), 1.0V/cell(NiMH)
Voltage level: 3.6V/cell
Max. charge voltage: 4.1V/cell
Allowable fast charge current: 1C or less
Min. discharge voltage cut off level: 2.5V/cell or higher
Voltage level: 3.3V/cell
Max. charge voltage: 3.6V/cell
Allowable fast charge current: 4C or less(e.g. A123M1)
Discharge voltage cut off level: 2.0V/cell or higher
Voltage level: 2.0V/cell
Voltage level: 3.7V/cell
Max. charge voltage: 4.2V/cell
Allowable fast charge current: 1C or less
Discharge voltage cut off level: 3.0V/cell or higher
NiCd/NiMH
Lilo
LiFe
LiPo
Pb
LiHV
Voltage level: 3.8V/cell
Max. charge voltage: 4.35V/cell
Allowable fast charge current: 1C or less
Min.discharge voltage cut off level: 3.0V/cell
(Lead-acid) max. charge voltage: 2.46V/cell
Allowable fast charge current: 0.4C or less
Discharge voltage cut off level: 1.50V/cell or higher
• Never leave the charger unsupervised when it is connected to its power supply. If any
malfunction is observed immediately terminate the process and refer to the operation manual.
• Keep the charger away from dust, water, heat, direct sunlight and vibration.
• The circuit of this unit can be powered by AC 100-240V or DC 11~18 volt power source.
• This unit and the battery to be charged or discharged should only be set upon a heat resistant,
non-flammable and non-conductive surface. Never charge on a car seat, carpet or similar
surface. Keep all flammable or volatile materials well away from operating area.
• Be sure to understand the specifications of the battery to be charged or discharged. If the
program is set up incorrectly the battery can be severely damaged. Lithium batteries when
improperly charged or discharged, can cause permanent damage or fire.
• To avoid short-circuits between the charge leads, always connect the charge cable to the unit
first, and only then to the battery to be charged or discharged. Reverse the sequence when
disconnecting.
• Do not attempt to disassemble battery packs.
MULTI CHEMISTRY
BALANCE CHARGER
AC-DC