Instructions for use

Use this setting to discharge a Lithium pack. The charge current and pack

voltage are adjustable using the methods shown previously in the charge

and balance instructions. Never exceed 1C for the discharge rate and

never use a ﬁnal voltage lower than what is recommended by the battery

manufacturer. The balance plug of the battery must be plugged into the

charger for a proper discharge to take place. Press and hold the START/

ENTER button to conﬁrm cell count, then press the button again a second

time to start the discharge process.

The processor monitors the voltage of individual cells during ‘storage-mode’ and ‘discharge’ of a Lithium

battery pack. It tries to regulate the voltages to be equal. For this feature, the balance plug of the battery

pack must be connected to the balance port of the charger. If the voltage of any one or more cells varies

abnormally during the procedure, it terminates the process with an error message. If this happens, the

battery pack contains a bad cell, or there is a bad connection at the balance plug. You can easily know

which one cell is bad by pressing the increase button with the error message on screen to show the

individual cell voltages. This method of viewing cell voltages can be used

during any lithium battery charge, or discharge process provided the

balance lead from the battery is plugged into the charger.

In this example, the charger found that the voltage of one of the cells in this

4S pack is too low.

By pressing the “increase” button when the error message is displayed,

we can see that cell #4 is reading 2.18, which is below the minimum

recommended 3.0 per cell. If all cells read 0.00, the balance lead from

the battery may have come disconnected. Also check your balance port

connection at the charger.

Select LiHV battery with standard Voltage 3.8V from setting program, double

conﬁrm the battery type when charging. If it’s not LiHV battery, press Stop

button to exit; if it’s conﬁrmed LiHV battery, then go to the program.

Warning: The LiHV mode only supports 4.35V LiHV batteries. Do not use

any other battery type in this mode. Never charge a 4.20V LiPo battery

under this mode as it may cause the battery to catch ﬁre or explode.

When discharging, the screen provides useful information like the

discharge rate, number of cells being discharged, battery voltage and the

amount of mAh, or capacity that the charger has removed from the pack

being currently discharged. Press Batt type/Stop to stop the discharging

process at any time.

MULTI CHEMISTRY

BALANCE CHARGER

AC-DC