Installation Instructions

1. Before installing the bulb, shut off power supply at the circuit breaker
panel to avoid electrical shock. It is recommended that surge/lightning
protection be installed. Ballast must be bypassed if present.
2. Remove old bulb.
3. Screw new bulb in clockwise. Do not overtighten. Overtightening may
cause damage to the light.
4. Individually pivot each of the 4 adjustable panels down to best cover the
desired space. Depending on the type of light fixture, it may be necessary to
pivot light heads out of the way before screwing the bulb into the fixture.
6. Restore power.
7. Turn on light switch. Bulb will illuminate immediately.
8. Adjust all angles as needed.
9. Do not stare directly into LED lights when adjusting settings.