Technical Specifications

- Do not dismantle this light. There are NO replaceable LEDs or serviceable parts.
- Do not install this light inside of undersized enclosures.
- Suitable for fixtures rated for temperatures ranging from -4˚F to 113˚F.
- Not Suitable for enclosed fixtures.
- Not for use on HID fixtures.
- Not for use on ballasted fixtures.
- Do not use where exposed to standing water.
- Do not leave bare wires exposed outside of the electrical connections.
- Make sure wiring section is insulated.
- DO NOT USE WITH DIMMERS. This lamp is not usable with any sort of dimmer.
- Using this lamp with dimmer of any kind will void the warranty.
This device complies with Part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation. Warning: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that the interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
(1) Reorient or relocate the receiving antenna. (2) Increase the separation between the
equipment and receiver. (3) Connect the equipment into an outlet on a circuit different from
that of the receiver. (4) Consult the dealer or an experienced radio/TV technician for help.
Installation: GT-BU-2500 | 2500LM/26W Motion Detecting LED E26 Bulb
ADDITIONAL WARNINGS: