Use and Care Manual

STRING LIGHT CONSTRUCTION:
AA. Power Cord (Male End)
BB. Connection between 10ft strings
CC. Power Connection (Female End)
DD. Adjustable Plastic Strap
EE. Carabiner Clip
FF. Pivoting Socket
GG. Light Head
TO USE
1. Hang light head (GG) using carabiner clip (EE) or adjustable
strap (DD) where light is needed. Use individually or linked.
a. Do not use electrical cord to hang.
b. It is recommended to hang light head at approximately
10ft height for optimal light coverage.
c. Plastic strap (DD) can be secured at different slots to best
fit the width of board. Do not use plastic strap on hot
surfaces such as water pipes.
2. Rotate light head at the pivoting socket (FF) until it is pointing
to the intended area.
3. If desired, link additional 10ft strings by inserting male end
(AA) of additional string into connecting female end (CC) of
previous string. Up to 45 lights (450 feet) can be connected
on one power outlet.
a. Always ensure connection between strings (BB) is secure.
b. When not in use, use plastic flap to close female end of
power cord (CC) to help keep out dust and moisture.
4. Continue steps 1, 2 and 3 until all lights/strings are mounted
as desired.
5. Plug in male end (AA) power cord into outlet.
6. All lights will illuminate immediately.
7. Unplug lights from power when moving the light heads or
adjusting the carabiner clip or plastic strap.
TROUBLESHOOTING
Problem
Cause
Solution
Lights are not
lighting up.
No power or faulty
connection.
Check that all
connections (BB)
are secure, and
power is ON.
Other issue
-
Contact GT-Lite
Customer Service:
1-800-865-6799
CARE AND CLEANING
Your fixture is made from quality materials that will last an
extended period of time with proper care. Periodically clean the
surface of the fixture.
1. Use a mild, non-abrasive cleaner. Do not use any solvents or
harsh cleaning agents.
2. Use a soft, non-abrasive cloth.
3. Lightly spray cleaner onto the cloth. Do not spray liquid
cleaners directly onto LEDs, power cord, or any part of this
product.
4. Lightly wipe down fixture with damp cloth. Allow product to dry
completely before restoring power and using LED lights.
AA CC
BB
EE
FF
GG
DD