Operation Manual

102 103
PART II
PEGS
Some models may come equipped with 2 or 4 pegs.
To install pegs, DO NOT loosen or remove axle nuts.
Check to make sure axle nuts are properly tightened
before installing and tightenings the pegs. Thread
the pegs on the axle over the axle nut, and insert a
screwdriver or similar tool through the peg holes and
tighten by turning the peg with the tool.
WARNING
Periodically check to make sure both
pegs are in good condition, not damaged,
and make sure they are both securely
tightened.
Front/Rear
dropouts
Front/Rear
wheel hub
Retaining washer
Step
retaining washer
Axle nut
Peg
APPENDIX G.