User's Manual
Table Of Contents
- Installation / User Manual
- Chapter 1 Introduction
- Chapter 2 Installation
- Chapter 3 Maintenance
- Chapter 4 Troubleshooting
- Appendix A Technical Specifications
- Appendix B Safety Characteristics and Certification
- Appendix C EC Declaration of Conformity
- Appendix D Innovation, Science and Economic Development Canada Statement
- Appendix E FCC part 15 statement
- Appendix F FCC RF Exposure
- Appendix G FDA declaration
- Appendix H Reduction of Hazardous Substances
- Appendix I Disposal and Recycling Information
- Appendix J California Proposition 65
- Appendix K Product material composition
- Appendix L Packaging Characteristics
- Appendix M EDGE GSF LFID ANTENNA - End-of-Life Disassembly
Chapter 1: Introduction
Safety Messages
DANGER
Turn off the main electrical disconnect switch prior to servicing any of the boxes.
Failure to do so might lead to serious injury or death.
Always use extreme caution when measuring voltage or performing procedures that require a
module to be powered on.
Electrostatic Discharge Prevention When Manipulating a Printed Circuit
Board (PCB)
Electrostatic discharge (ESD) can damage equipment and impair electrical circuitry. ESD damage occurs
when electronic components are improperly handled and can result in complete or intermittent failures.
Always follow ESD on a PCB-prevention procedures when you remove and replace components. Ensure
that the chassis is electrically connected to earth ground. Wear an ESD-preventive wrist strap, ensuring
that it makes good skin contact. Connect the grounding clip to an unpainted surface of the chassis frame
to safely ground unwanted ESD voltages. To guard against ESD damage and shocks, the wrist strap and
cord must operate properly. If no wrist strap is available, ground yourself by touching the metal part of the
chassis.
For safety, periodically check the resistance value of the antistatic strap, which should be between 1 and
10 megohm (Mohm).
Telecommunication Advice
EDGE GSF LFID Antenna
The EDGE GSF has also a radio accessory: EDGE GSF LFID Antenna.
FCC ID and IC ID
The FCC ID of the EDGE GSF LFID Antenna is 2AFLZGSFLFID.
The IC ID of the EDGE GSF LFID Antenna is 11880A-GSFLFID.
FCC Caution and Safety Notices
Any changes or modifications (including the antennas) made to this device that are not expressly
approved by the manufacturer may void the user’s authority to operate the equipment. This device and its
antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter.
FCC Antenna Gain Restriction
The radio device does not allow the possibility to use another antenna. It uses a coil antenna.
IC Detachable Antenna Gain Restriction
The radio device does not allow the possibility to use another antenna. It uses a coil antenna.
Health and radiation
This equipment should be installed and operated with minimum distance 20 cm (7-7/8 in.) between the
radiator and your body.
8
890-00682 EDGE GSF LFID Antenna