User's Manual

2 Installation
Topics Covered in this Chapter
▪ Mounting the Antenna and Antenna Plate
▪ EDGE GSF LFID Antenna Connections
Mounting the Antenna and Antenna Plate
The EDGE GSF LFID Antenna must be installed to the stall before connecting it to the EDGE GSF
Feeder.
What You Should Know
These instructions only cover the installation of the EDGE GSF LFID Antenna to the GSF stalls. Refer to
the GSF Stall assembly and installation manual for details on stall installation. See figure below for all
references to hardware and parts listed in steps.
1. Attach the antenna (13) to the antenna plate (15) by installing the two screws (16) from the backside
of the antenna plate (15) and secure with the washers (17) and lock nuts (18).
2. Mount the antenna plate supports (14) with the hardware shown, do not fully tighten the hardware.
3. Position the antenna assembly between the sides of the stall and install using the hardware as
shown.
NOTE: When assembling only one stall, install the hardware and fully tighten. However, when
assembling multiple stalls side by side, pre-assemble the antenna, antenna plates, and sup-
ports for all the stalls. Then position the antenna assemblies between the stall sides and
install the hardware through the two antenna assemblies that share the stall side.
890-00682 EDGE GSF LFID Antenna
13