Product Specs

Hui Zhou Gaoshengda Technology Co., LTD WXT05R2601
PAGE 5 OF 4
Version 1.0
Fine tuning of return loss etc. can be performed using a matching network.
Le présent émetteur radio [IC:12290A-WXT05] a été approuvé par Innovation, Sciences et
Développement économique Canada pour fonctionner avec les types d'antenne énumérés ci-dessous
et ayant un gain admissible maximal. Les types d'antenne non inclus dans cette liste, et dont le gain
est supérieur au gain maximal indiqué pour tout type figurant sur la liste, sont strictement interdits pour
l'exploitation de l'émetteur.
Le contenu concret à vérifier sont les trois points suivants.
１) １) doit utiliser une antenne comme PIFA avec pifa gain n'excédant pas 3 dBi
２) doivent être installés de façon que l'utilisateur final ne peut pas modifier l'antenne
３) La ligne d’alimentation doit être conçue en 50ohm
Le réseau correspondant peut être utilisé pour affiner la perte de retour, etc.
Notice to OEM integrator
Notice to OEM integrator
Must use the device only in host devices that meet the FCC/ISED RF exposure category of mobile, which
means the device is installed and used at distances of at least 20cm from persons.This transmitter must not be
co-located or operating in conjunction with any other antenna or transmitter.
The end user manual shall include FCC Part 15 /ISED RSS GEN compliance statements related to the
transmitter as show in this manual(FCC/ICanada statement). Host manufacturer is responsible for compliance of
the host system with module installed with all other applicable requirements for the system such as Part 15 B,
ICES 003. Host manufacturer is strongly recommended to confirm compliance with FCC/ISED requirements for
the transmitter when the module is installed in the host.
Must have on the host device a label showing Contains FCC ID: 2AC23-WXT05，IC: 12290A-WXT05
The use condition limitations extend to professional users, then instructions must state that this information also
extends to the host manufacturer’s instruction manual.
This module is stand-alone modular. If the end product will involve the Multiple simultaneously transmitting
condition or different operational conditions for a stand-alone modular transmitter in a host, host manufacturer
have to consult with module manufacturer for the installation method in end system. Any company of the host
device which install this modular should perform the test of radiated &condicted emission and spurious emission
etc. according to FCC Part 15C: 15.247 and 15.209 &15.207, 15.407, 15B class B requirement, only if the test
result comply with FCC part 15C: 15.247 and15.209 & 15.207, 15.407, 15B class B requirement. Then the host
can be sold legally.
This modular transmitter is only FCC authorized for the specific rule parts ( 47CFR Part 15.247and 15.407)
listed on the grant, and that the host product manufacturer is responsible forcompliance to any other FCC rules
that apply to the host not covered by the modular transmitter grant of certification. Host manufacturer is strongly
recommended to confirm compliance with FCC/ISED requirements for the transmitter when the module is
installed in the host.
Must have on the host device a label showing Contains FCC ID: 2AC23-WXT05 and Contains IC:
12290A-WXT05
l'hôte doit utiliser l'instrument uniquement dans des dispositifs qui répondent à la fcc / (catégorie d'exposition rf
mobile, ce qui signifie le dispositif est installé et utilisé à une distance d'au moins 20 cm de personnes. le