Product Specs
Hui Zhou Gaoshengda Technology Co., LTD WXT05R2601
PAGE 3 OF 4
Version 1.0
Antennas:
2.4G
5G
ANT1:PIFA antenna & 2 dBi
ANT1:PIFA antenna & 3 dBi
ANT2:PIFA antenna & 2.98 dBi
ANT2:PIFA antenna & 2.8 dBi
BT Antenna:
BRADE
TYPE
GAIN
GSD
PIFA antenna
2 dBi
Note: 1. The WIFI antenna 2 is non-detachable that permanently attached, can’t be replaced.
2. WIFI antenna 1 & BT antenna are detachable antennas.
3. Must use the same antenna type and gain equal to or lower than in the tables above.
The concrete contents to check are the following three points.
１) Must use the same antenna type and gain equal to or lower than in the tables above.;
２) Should be installed so that the end user cannot modify the antenna;
３) Feed line should be designed in 50ohm
Fine tuning of return loss etc. can be performed using a matching network.
Canada Statement
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the
following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage;
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter. This equipment should be installed and operated with a minimum distance of 20
centimeters between the radiator and your body.
Cet émetteur ne doit pas être Co-placé ou ne fonctionnant en même temps qu'aucune autre antenne
ouémetteur.Cet équipement devrait être installé et actionné avec une distance minimum de 20
centimètres entre leradiateur et votre corps.
The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and
compliance with RSS-102 RF exposure, users can obtain Canadian information on RF exposure and
compliance.
Le dispositif rencontre l'exemption des limites courantes d'évaluation dans la section 2.5 de RSS 102
etla conformité à l'exposition de RSS-102 rf, utilisateurs peut obtenir l'information canadienne
surl'exposition et la conformité de rf.
Please notice that if the ISED certification number is not visible when the module is installed inside
another device, then the outside of the device into which the module is installed must also display a
label referring to the enclosed module. This exterior label can use wording such as the following:
“Contains IC:12290A-WXT05” any similar wording that expresses the same meaning may be used.