Product Specs

Hui Zhou Gaoshengda Technology Co., LTD WCT5JM2611

PAGE 3 OF 8

Version 1.0

The devices must be installed and used in strict accordance with the manufacturer's instructions as described

in the user documentation that comes with the product.

Any company of the host device which install this modular with limit modular approval should perform the

test of radiated & conducted emission and spurious emission,etc. according to FCC part 15C : 15.247 and

15.209 & 15.207 ,15B Class B and 15.407 Subpart E requirement, Only if the test result comply with FCC

part 15C : 15.247 and 15.209 & 15.207 ,15B Class B and 15.407 Subpart E requirement，then the host can be

sold legally.

CFR 47 FCC PART 15 SUBPART C has been investigated. It is applicable to the modular transmitter

This radio transmitter 2AC23-WCT5J has been approved by Federal Communications Commission

to operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna types

not included in this list that have a gain greater than the maximum gain indicated for any type listed are

strictly prohibited for use with this device.

unique antenna connector (IPEX) must be used on the Part 15 authorized transmitters used

in the host product.

The concrete contents to check are the following three points.

1) Must use following one of the six antenna.

2) Should be installed so that the end user cannot modify the antenna;

3) Feed line should be designed in 50ohm

Fine tuning of return loss etc. can be performed using a matching network.

Antenna information

Manufacture: Hui Zhou Gaoshengda Technology Co.,LTD

BT antenna

Antenna model Frequency (MHz) Antenna Type Antenna Gain (dBi)

WCT5H-20 2402-2480 PIFA Antenna 2.77

WCT5H-40 2402-2480 PIFA Antenna 2.60

WCT5H-60 2402-2480 PIFA Antenna 2.71

WCT5J-20 2402-2480 PIFA Antenna 2.88

WCT5J-40 2402-2480 PIFA Antenna 2.73

WCT5J-60 2402-2480 PIFA Antenna 2.79