Product Specs

Hui Zhou Gaoshengda Technology Co., LTD WCT2DM2611
PAGE 3 OF 6
Version 1.0
The device must be professionally installed
The intended use is generally not for the general public.It is generally for
industry/commercial use.
The connector is within the transmitter enclosure and can only be accessed by disassembly
of the transmitter that is not
normally required. the user has no access to the connector.
Installation must be controlled. Installation requires special training
This module has been assessed against the following FCC rule parts: CFR 47 FCC Part 15 C
(15.247, DTS and DSS) and CFR 47 FCC Part 15 E (NII). It is applicable to the modular
transmitter
The module is limited to OEM installation ONLY.
The OEM integrator is responsible for ensuring that the end-user has no manual instruction
to remove or install module.
The module is limited to installation in mobile application.
A separate approval is required for all other operating configurations, including portable
configurations with respect to Part 2.1093 and difference antenna configurations.
There is requirement that the grantee provide guidance to the host manufacturer for
compliance with Part 15B requirements.
The module complies with FCC Part 15.247 / Part 15.407 and apply for Single module approval.
Trace antenna designs: Not applicable.
Antennas:
BT
BLE
Antenna 1: PIFA antenna & 2.
88
dBi
Antenna 1: PIFA
a
ntenna & 2.
88
dBi
Antenna 2:
FPC
antenna & 2.
77
dBi
Antenna 2:
FPC
antenna & 2.
77
dBi
Note: The EUT only has one Antenna connector and the supplier provide two type of antennas.
The device can support PIFA or FPC antenna for BT & BLE.
2.
4G
5G
Antenna 1: PCB antenna & 2.29 dBi Antenna 1: PCB antenna & 2.73 dBi
Antenna 2: PCB antenna & 2.29 dBi
Antenna
2
: P
CB
antenna & 2.
73
dBi
Canada Statement
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to
the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage;
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d’en compromettre le fonctionnement.