Product Specs

Hui Zhou Gaoshengda Technology Co., LTD WCT16R2601F
PAGE 3 OF 6
Version 1.0
The module is limited to OEM installation ONLY.
The OEM integrator is responsible for ensuring that the end-user has no manual instruction to
remove or install module.
The module is limited to installation in mobile application.
A separate approval is required for all other operating configurations, including portable
configurations with respect to Part 2.1093 and difference antenna configurations.
There is requirement that the grantee provide guidance to the host manufacturer for compliance
with Part 15B requirements.
The module complies with FCC Part 15.247 / Part 15.407 and apply for Single module approval.
Trace antenna designs: Not applicable.
The device must be professionally installed The intended use is generally not for the general
public.It is generally for industry/commercial use.The connector is within the transmitter enclosure
and can only be accessed by disassembly of the transmitter that is not normally required. the user
has no access to the connector. Installation must be controlled. Installation requires special
training This module has been assessed against the following FCC rule parts: CFR 47 FCC Part
15 C (15.247, DTS and DSS) and CFR 47 FCC Part 15 E (NII). It is applicable to the modular
transmitter。
This radio transmitter FCC ID: 2AC23-WCT16 has been approved by Federal Communications
Commission to
operate with the antenna types listed below, with the maximum permissible gain indicated.
Antenna types not included in this list that have a gain greater than the maximum gain indicated
for any type listed are strictly prohibited for use with this device.
Antennas:
2.4G
5G
PIFA antenna 1 ：2 dBi
PIFA antenna 2：2.98 dBi
PIFA antenna 1 ： 3 dBi
PIFA antenna 2 ： 2.80 dBi
BT Antenna:
BRADE
TYPE
GAIN
GSD
PIFA antenna
2 dBi
Note: 1. The WIFI antenna 2 is permanently attached, can’t be replaced.
2. Must use the same antenna type and gain equal to or lower than in the tables above.
The concrete contents to check are the following three points.
１) Must use the same antenna type and gain equal to or lower than in the tables above.;
２) Should be installed so that the end user cannot modify the antenna;
３) Feed line should be designed in 50ohm
Fine tuning of return loss etc. can be performed using a matching network.