Product Specs

Hui Zhou Gaoshengda Technology Co., LTD WC5FM2601F
PAGE 6 OF 7
Version 1.0
0
2412 ~ 2462
PIFA
1.72
Shenzhen Yishengbang Technology
Company Limited
1
2412 ~ 2462
PIFA
2
/
Note: Antenna 1 is permanently attached, can’t be replaced.
5G WIFI
Antenna Group 1
Antenna
No.
Frequency
(MHz)
Antenna Type
Maximum Antenna
Gain (dBi)
Manufacturer
0
5180 ~ 5825
PIFA
4.13
Zhongshan B&T Communication
Technology Co., Ltd
1
5180 ~ 5825
PIFA
3
/
Antenna Group 2
Antenna
No.
Frequency
(MHz)
Antenna Type
Maximum Antenna
Gain (dBi)
Manufacturer
0
5180 ~ 5825
PIFA
2.57
Shenzhen Yishengbang Technology
Company Limited
1
5180 ~ 5825
PIFA
3
/
Note: Antenna 1 is permanently attached, can’t be replaced.
Notice to OEM integrator
Must use the device only in host devices that meet the FCC/ISED RF exposure category of mobile, which means the
device is installed and used at distances of at least 20cm from persons.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
The end user manual shall include FCC Part 15 /ISED RSS GEN compliance statements related to the transmitter as
show in this manual(FCC/ICanada statement).
Host manufacturer is responsible for compliance of the host system with module installed with all other applicable
requirements for the system such as Part 15 B, ICES 003.
Host manufacturer is strongly recommended to confirm compliance with FCC/ISED requirements for the transmitter
when the module is installed in the host.
The use condition limitations extend to professional users, then instructions must state that this information also
extends to the host manufacturer’s instruction manual.
This module is stand-alone modular. If the end product will involve the Multiple simultaneously transmitting
condition or different operational conditions for a stand-alone modular transmitter in a host, host manufacturer
have to consult with module manufacturer for the installation method in end system.
Any company of the host device which install this modular should perform the test of radiated &
condicted emission and spurious emission etc. according to FCC Part 15C: 15.247 and 15.209 &
15.207, 15B class B requirement, only if the test result comply with FCC part 15C: 15.247 and
15.209 & 15.207, 15B class B requirement. Then the host can be sold legally.
This modular transmitter is only FCC authorized for the specific rule parts ( 47CFR Part 15.247
and 15.407) listed on the grant, and that the host product manufacturer is responsible for
compliance to any other FCC rules that apply to the host not covered by the modular transmitter
grant of certification.
Host manufacturer is strongly recommended to confirm compliance with FCC/ISED