Product Specs

Hui Zhou Gaoshengda Technology Co., LTD WC5EM2601F
PAGE 4 OF 5
Version 1.0
admissible maximal. Les types d'antenne non inclus dans cette liste, et dont le gain est supérieur au
gain maximal indiqué pour tout type figurant sur la liste, sont strictement interdits pour l'exploitation de
l'émetteur.
The concrete contents to check are the following three points.
１) Must use a PIFA antenna such as WC0D-60 with gain not exceeding 3 dBi
２) Should be installed so that the end user cannot modify the antenna
３) Feed line should be designed in 50ohm
Fine tuning of return loss etc. can be performed using a matching network.
Le contenu concret à vérifier sont les trois points suivants.
１) doit utiliser une antenne comme WC0D-60 avec pifa gain n'excédant pas 3 dBi
２) doivent être installés de façon que l'utilisateur final ne peut pas modifier l'antenne
３) La ligne d’alimentation doit être conçue en 50ohm
Le réglage précis de la perte de rendement, etc. peut être effectué en utilisant un réseau correspondant.
Detachable Antenna:
2.4G 5G
Antenna 1: PIFA antenna & 2.0 dBi Antenna 1: PIFA antenna & 3.0 dBi
undetachable Antennas:
2.4G 5G
Antenna 2: PIFA antenna & 2.0 dBi Antenna 2: PIFA antenna & 3.0 dBi
Antenna 2 is permanently attached, can’t be replaced.
Notice to OEM integrator
Must use the device only in host devices that meet the FCC/ISED RF exposure category of mobile, which means the
device is installed and used at distances of at least 20cm from persons.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
The end user manual shall include FCC Part 15 /ISED RSS GEN compliance statements related to the transmitter as
show in this manual(FCC/ICanada statement).
Host manufacturer is responsible for compliance of the host system with module installed with all other applicable
requirements for the system such as Part 15 B, ICES 003.
Host manufacturer is strongly recommended to confirm compliance with FCC/ISED requirements for the transmitter
when the module is installed in the host.
The use condition limitations extend to professional users, then instructions must state that this information also
extends to the host manufacturer’s instruction manual.
This module is stand-alone modular. If the end product will involve the Multiple simultaneously transmitting
condition or different operational conditions for a stand-alone modular transmitter in a host, host manufacturer
have to consult with module manufacturer for the installation method in end system.