Product Specs

Hui Zhou Gaoshengda Technology Co., LTD WC0HR2611
PAGE 3 OF 4
Version 1.0
is connected.
—Consult the dealer or an experienced radio/TV technician for help.
If the FCC identification number is not visible when the module is installed inside another
device, then the outside of the device into which the module is installed must also display
a label referring to the enclosed module. This exterior label can use wording such as the
following: “Contains Transmitter Module FCC ID: 2AC23-WC0HR2601 Or Contains FCC ID:
2AC23-WC0HR2601”.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment
- Information on test modes and additional testing requirements
Any final host product with the modular transmitter installed should be under test according
to guidance given in KDB 996369 D04. To enter test mode for module,
MP_Kit_RTL11ac_8822BU_USB_v5.01 software and command is necessary. When something wrong
happens in configuring test modes for host product with module, host product manufacturer
should coordinate with module manufacturer for technical support. It is recommended that
some investigative measurements should be taken to confirm that host product with module
installed does not exceed the spurious emissions limits or band edge limits.
- Additional testing, Part 15 Subpart B disclaimer
The modular transmitter is only FCC authorized for the specific rule parts (FCC Part
15.247&15.407) list on the grant, and that the host product manufacturer is responsible
for compliance to any other FCC rules that apply to the host not covered by the modular
transmitter grant of certification. The final host product still requires Part 15 Subpart
B compliance testing with the modular transmitter installed when contains digital circuity.
Canada Statement
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to
the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage;
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d’en compromettre le fonctionnement.