Product Specs

Hui Zhou Gaoshengda Technology Co., LTD
W2RM2510F
PAGE 2 OF 4
Version 1.0
NOTICE:
◆ please keep this product and accessories attached to the places which children can't touch;
◆ do not splash water or other liquid onto this product, otherwise it may cause damage;
◆ do not put this product near the heat source or direct sunlight, otherwise it may cause deformation
◆ or malfunction;
◆ please keep this product away from flammable or naked flame;
◆ please do not repair this product by yourself. Only qualified personnel can be repaired.
FCC Statement:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Caution: The user is cautioned that changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
If power exceeds the limit and the distance（Over 20cm distance in actual use between the device and user） is compliant with the
requirement
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be
installed and operated with a minimum distance of 20cm between the radiator and any part of your body.
Notice to OEM integrator
If the FCC ID is not visible when the module is installed inside another device, then the outside of the
device into which the module is installed must also display a label referring to the enclosed module.
The end product shall haves the words “Contains Transmitter Module FCC ID: 2AC23-W2R”.
The device must be professionally installed
The intended use is generally not for the general public.It is generally for industry/commercial use.
The connector is within the transmitter enclosure and can only be accessed by disassembly of the transmitter that is not normally
required. the user has no access to the connector.
Installation must be controlled. Installation requires special training
FCC standards: FCC CFR Title 47 Part 15 Subpart C Section 15.247
Any company of the host device which install this modular with unlimit modular approval should perform the tast of
radiated & conducted emission and spurious emission, etc. according to FCC part 15C: 15.247 and 15.209
& 15.207, 15B Class B requirement, only if the test result comply with FCC part 15C: 15.247 and 15.209 &
15.207, 15B Class B requirement, then the host can be sole legally.
PIFA antenna with Gain 3dBi
When the module is instaed inside another device, the user manual of the hose contain below warning statement:
1) This device may not cause harmful interference.
2) Thhis device must accept any interference received, including interference that may cause undesiredoperation.