Product Specs

Hui Zhou Gaoshengda Technology Co., LTD W2GM2500T
PAGE 2 OF 3
Version 1.0
FCC Statement
- List of applicable FCC rules
This device complies with FCC part 15C : 15.247.
- Summarize the specific operational use conditions
This device and its antenna(s) must not be co-located or operating in conjunction with any other
antenna or transmitter. And the module should be installed at a minimum distance of 20 cm away
from person nearby. The host product manufacturer should state this information to the host
instruction manual.
- Trace antenna designs
Not applicable.
- RF exposure considerations
This modular complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter. This modular must be installed and operated with a minimum distance
of 20 cm between the radiator and user body.
- Antennas
Antenna Type: PCB Antenna
Antenna Gain: 2 dBi
The antenna is permanently attached and not consideration of replacement.
- Label and compliance information
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Caution: The user is cautioned that changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
—Consult the dealer or an experienced radio/TV technician for help.
If the FCC identification number is not visible when the module is installed inside another
device, then the outside of the device into which the module is installed must also display