User Manual
Table Of Contents
- 1. INTRODUCTION
- 2. SYSTEM CONFIGURATION
- 2.1. Smart-Cell Repeater Service Network Configuration
- 2.2. System Design and Operation
- 2.2.1. System Design
- 2.2.2. Downlink/ Uplink Path
- 2.2.3. 700MHz Frequency Selection (LTE)
- 2.2.4. 800MHz Frequency Selection (iDEN)
- 2.2.5. 850MHz Frequency Selection (Cellular)
- 2.2.6. 1900MHz Frequency Selection (PCS)
- 2.2.7. 2100MHz Frequency Selection (AWS)
- 2.2.8. 2600MHz Frequency Selection (BRS)
- 2.2.9. 2500MHz Frequency Selection (TD-LTE)
- 3. SYSTEM SPECIFICATIONS
- 4. SETUP
Repeater User Manual
SmartCell Repeater
5
Antennas must be installed in accordance with FCC 27.50 and SRSP 518.
Please note that EIRP based on antenna gain after accounting for cable loss should
be less than 50 Watt (47 dBm) for Donor side. For Service side, with 3dBi gain antennas
the height of the antenna above average terrain (HAAT) must not exceed 14.496 m.
For different gain antennas refer to the relevant rules.
5) FCC Warning Label
WARNING. This is NOT a CONSUMER device. It is designed for installation by FCC LICENSE
and QUALIFIED INSTALLERS. You MUST have an FCC LICENSE or express consent of an FCC
Licensee to operate this device.
Unauthorized use may result in significant forfeiture penalties, including penalties in excess
of $100,000 for each continuing violation.