User's Manual

RF Cable Connections: Bottom of The Repeater
• Take out three SMA (M) to SMA (M) type RF cables.
• While connecting the PSU and the DFM units underneath, use referenced cable and pay attention to the labels. Plug them into
their corresponding outlets.
• User may choose either of the two SMA ports on the bottom of the PSU to connect to the DFM.
• User may choose any two of the four SMA ports on the bottom of the PSU to connect to amplifiers.
CAUTION
Please, pay attention while connecting PSU and DFM, PSU and 800/900 AMP. The repeater will not work if
connection is inappropriate.
<Picture 8> Bottom View of the Repeater.
14
10M REF.
13 12 11 10 9 7 6 5 4 3 2 1
14151617181920
8
2122232425
1. RS485_P
2. RS485_N
3. GND
4. INSERT
5. RESET 6. NC
7. ID_RESERVE
8. GND 9. ID1
10. ID2 11~14. COM_GND 15~18. NC 19~22. COM_GND
23. 27.5V 24. 27.5V 25. 6.5V
INTERFACE
10M REF.
13
12 11
10 9 7 6 5
4
3
2 1
14151617181920
8
2122232425
1. RS485_P
2. RS485_N
3. GND
4. INSERT
5. RESET 6. NC
7. ID_RESERVE
8. GND 9. ID1
10. ID2 11~14. COM_GND 15~18. NC 19~22. COM_GND
23. 27.5V 24. 27.5V 25. 6.5V
AMP INTERFACE
10M REF.
10 9 7 6 5
4
3
2 1
11121617181920
8
1. RS485_P
2. RS485_N
3. GND
4. INSERT
5. RESET 6. NC
7. ID_RESERVE
8. GND 9. ID1
10. ID2 11~16. COM_GND 17~20. NC
A1. 5.5V
INTERFACE
1415 13
A1
C A
B
1: VCC
2: VCC
3: GND
4: GND
INTERFACE
EXTRA
SNMP
A: AC
B: AC
C: F.G
DC OUT
DFM
AMP
AMP INTERFACE
DFM INTERFACE
AMP INTERFACE
EXPAND FOR QUAD
AMP INTERFACE DFM INTERFACE AMP INTERFACE
1.
A B C