User's Manual

Version

1.0

Date

NOV. 27, 2018

Page

10/ 42

Title

USER MANUAL

Prepared by

KO. SUNGMOO

Reviewed by

Approved by

1.3.1 FCC Part 15.105

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when

the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful

interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful

interference in which case the user will be required to correct the interference at his own expense.

1.3.2 FCC Caution

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's

authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any

other antenna or transmitter. Use of unauthorized antennas, cables, and/or coupling devices not conforming with

ERP/EIRP and/or indoor‐only restrictions is prohibited.

1.3.3 Radiation Exposure Statement

The product complies with the FCC RF exposure limit set forth for an uncontrolled environment and is

safe for intended operation as described in this manual. The further RF exposure reduction can be achieved if the

product can be kept as far as possible from the user's body or set the device to lower output power if such a

function is available.

1.3.4 FCC Warning Labels

1) FCC Part 15.19

The FCC Certification label has attached right side of the device. The FCC Certification label contained FCC

15.19 warning statement, Device type (A or B), FCC, ISED and UL ID

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)

This device may not cause harmful interference, and (2) This device must accept any interference received,

including interference that may cause undesired operation.

2) FCC Part 90.219

Booster Warming Label is attached left side of the device. This label has contains FCC 90.219, IC warning

statements and contact phone number for a trouble shooting.

3) FCC Part 90 Class B

Prior to equipment use the service must be registered with the FCC.

This can be done through the FCC’s website at https://signalboosters.fcc.gov/signal-boosters