HOME 5000 User Guide www.americanbst.
Memo This publication provides instructions for installing Cellular Signal Booster Home 5000. Copyright© 2019, American Booster Inc. All Rights Reserved. Revision History Date Version Changes 2019, January Version 1.0 Original Certification This equipment complies with the FCC / IC directives. Technical Support : 913 469 6699 www.americanbst.
WARRANTY Opening or tampering with the Signal Booster will void all warranties. INDEX American Booster provides a 2-year warranty with all of its equipment. Every product of American Booster is guaranteed to be free of material defects or component malfunctions. This warranty does not cover any Signal Boosters that have been exposed to any misuse, abuse, Product Introduction 4 physical damage or inadequate maintenance.
HOME 5000 IC Warning Statements RSS-GEN, Sec. 7.1.2 – (transmitters) Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
FCC Warning Statements Package Contents FCC Part 15.105 statement Class B This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Application Example Safety Guidelines WARNING ELECTRIC SHOCK Opening the Signal Booster could result in electric shock and may cause severe injury. DAMAGE TO EQUIPMENT Use only the power supply provided in this package. Operating the Signal Booster with antennas in very close proximity facing each other could lead to a severe damage to the Signal Booster. The installation height of the antenna for AWS band (1700/2100 MHz) operations is limited to 10 meters above ground for compliance with Section 27.
Specifications HOME 5000 Optional Kit Parameter Downlink Uplink Remark 700MHz LTE 734~757MHz 704~716MHz 776~787MHz Band 17 & 13 850MHz Cellullar 1900MHz PCS 2100MHz AWS Output Power Maximum Gain Noise Figure Impedance RF Connector Power Connector Power Size, inch Weight, lbs Operation Temperature Humidity 869~894MHz 1930~1990MHz 2110~2155MHz 824~849MHz 1850~1910MHz 1700~1755MHz 5dBm 23dBm Optional components enable signal amplification to a further area.
Installation Guide Troubleshooting Instructions to fix flashing or solid red. STEP 1. Find the Strongest Signal If you have a good voice signal and fast data speeds even though one or two of LEDs are solid red, you may continue to use the Signal Booster as it is. However, if one of the LED’s has flashing or solid red, your voice signal is weak and data speeds are low, Then follow the troubleshooting steps below. 1-1. Using an iPhone Dial *3001#12345#*, then press Call. 1-2.
LED LED Indicators STEP 1. Find the Strongest Signal 700 850 1900 700 Note The stronger signal you receive from the base station, the better coverage you will have inside your house/office. 2100 850 1900 2100 -70dBm Flashing Green After the Signal Booster is powered on, flashing green will last for 20 seconds. It means that the Signal Booster is being set up for optimal performance.
STEP 2. Install the Outside Antenna The outside antenna is shaped like a triangle. This antenna must be mounted as high as possible on the exterior of the house or offic e, but never higher than 10m above the ground. Mount the outside antenna on the side of the house where you detected the strongest cell phone signal.
STEP 5. Install the Inside Antenna STEP 2. Install the Outside Antenna Inside Panel Antenna is directional, so the signal will be distributed from its front side in one direction. We would not recommend to install the Inside Antenna close to the floor. Install the outside antenna in a location where you can receive the strongest signal according to the instructions described in STEP 1. Make sure outside antenna is installed with the point of the triangle facing toward the cell tower.
STEP 3. Run the Outside Antenna Cable Connect the outside N-SMA cable with the yagi antenna. Then, connect the window flat cable with the outside cable. STEP 4. Run the Cable to the Booster Connect the cable from the booster to the window flat cable. To Booster Cable (20 ft.) HOME 5000 Cable Line Outside Antenna to 40 ft. cable Outside Antenna 40 ft. N-SMA Coaxial Cable 1 ft. Window Flat Cable 20 ft. SMA -SMA Coaxial Cable 70 0 85 0 19 00 21 00 Inside Antenna 12 HOME 5000 User Guide 25 ft.
Supplier's Declaration of Conformity 47 CFR § 2.1077 Compliance Information Unique Identifier: HOME 5000 Responsible Party – U.S. Contact Information GSTeletech,Inc. 8206 Marshall Drive, Lenexa, Kansas 66214 Contact point Charles You chyu@gsteletechinc.com Office : 1-913-469-6699 Fax : 1-913-661-0163 FCC Compliance Statement (e.g., products subject to Part 15) This device complies with Part 15 of the FCC Rules.
