User's Manual

FCC ID : U88GSTR-TRIT-SPR
HYUNDAI CALIBRATION & CERTIFICATION TECHNOLOGIES CO., LTD.
SAN 136-1, AMI-RI, BUBAL-EUP, ICHEON-SI, KYOUNGKI-DO, 467-701, KOREA
TEL:[phone] FAX:[phone] www.hct.co.kr
6
2. System Configuration
2.1 Tri-band repeater service network configuration
The system’s operation range is from A Block to G Block (Total: 65MHz) and the system features
- to set up 20MHz using 5MHz, 10MHz, 15MHz and contiguous ‘Block’
- to set up 3 non-contiguous 5MHz Block
- to set up Sub Block by 5MHz with 10MHz, 15MHz Block
- Remote control through GUI
This system is to provide iDEN800MHz and 900MHz simultaneously.
Available band selection
a. 18MHz Band of Downlink 851MHz~869MHz, Uplink 806MHz~824MHz
b. 7MHz Band of Downlink 862MHz~869MHz, Uplink 817MHz~824MHz
can select the 18MHz Band of Downlink 851MHz~869MHz, Uplink 806MHz~824MHz and
Downlink 862MHz~869MHz, 7MHz Band of Uplink 817MHz~824MHz on remote control.
Also, high frequency edge in Downlink side could be reduced by 200 KHz or 400 KHz to
attenuate adjacent band signal
- Simultaneous service of IDEN800MHz, iDEN900MHz
- IDEN800MHz remote band selection either 18MHz/7MHz
Downlink band-edge shifting is available (SAW Filter select)
Report No. : HCT-R07-020 6/37