User Manual
FCC ID : U88GSTR-815DC-SPR
HYUNDAI CALIBRATION & CERTIFICATION TECHNOLOGIES CO., LTD.
SAN 136-1, AMI-RI, BUBAL-EUP, ICHEON-SI, KYOUNGKI-DO, 467-701, KOREA
TEL:+82 31 639 8517 FAX:+82 31 639 8525 www.hct.co.kr
Report No. : HCT-R07-008 11/23
@CH offset 1MHz
> 55 dBm
@ Degradation of 3dB for eight iDEN carriers
@CH offset 2 MHz
> 55 dBm
@ Degradation of 3dB for eight iDEN carriers
@ 869 MHz 868.8MHz/868.6MHz Adjust
Band Edge
@ 940 MHz 939.8MHz/939.6MHz
Band Select Local Shift & RF Switching
Roll Offs > 50dBc
3.2 Electrical and Environment Specifications
Items specification
Size(mm) / Type 13(W)*18(L)*4.3(H) / Inch
Power
AC 120V 60Hz 1.4A
Temperature / Weight
0℃ ~ +50℃/16.7kg
Connector TYPE N Type Female
3.3 Functions
Parameter Specification
Gain Control
• Adjustable DL and UL Gain range 40~65dB
• Display default Gain and current Gain function
AGC
Auto Gain Control
• It always operates in Downlink AGC ON status
• To maintain same Downlink output power despite flexible input signal
strength.
• To add or subtract Attenuation level referring to AGC Power Limit level.
ALC
Auto Limit Control
• To limit output power as far as default range
• Set up via GUI
• Automatic Gain decrement when output power of repeater is higher than
default level
• Automatic Gain recovery when output power of repeater is reduced.
• Shutdown when output power is higher than default level in Minimum Gain
• Automatic Recovery Algorithm conversion after Shutdown status
Band Select
• In case of 800MHz FWD Band, it enables User to select one of 18MHz,
17.8MHz, 17.6MHz/ 7MHz, 6.8MHz, and 6.6MHz according to GUI setting.
• In case of 900MHz FWD Band, it enables User to select one of 5MHz,
4.8MHz, 4.6MHz according to GUI setting.
• In case of 800MHz RVS Band, it enables User to select one of 18MHz/
7MHz according to GUI setting.
• In case of 900MHz RVS Band, it enables User to select 5MHz according to
GUI setting.
Band Edge Adjust • To shift Band edge of DL high frequency side by 200kHz, 400kHz step
Power Monitoring
Function
• Monitoring repeater’s output level