User's Manual

Bell Mobility User Manual

In-building Repeater

4. SETUP

4.1. Equipment Needed for In-buildingRepeater Setup

Parameter Item Quantity Remark

Major Component Repeater GRS-DUO24M-BC 1 EA Provided by GST

Additional

Components

Mounting Bracket

CD which contains User Manual

V.1.0 and Installation Guide V.1.0

Ethernet Cable 6.6ft (2m)

Ground Cable 6.6ft (2m)

Ground Sems Screw M4 x 8mm

Bracket Sems Screw M6 x 16mm

Lag Screw 12.7mm x 50.8mm

Anchor Bolt Set 12.7mm x 50.8mm

1 EA

4 EA

Provided by GST

Antenna

Donor ANT

Server ANT

1 EA

Not Included

RF Cable Antenna connection Cable TBD Not Included

Testing and Measuring

Equipment

Spectrum Analyzer 1 EA Not Included

4.1.1 Checkpoints before turning on the Repeater

1) System Power Check: AC electrical power to the repeater should be 110V, input electricity

only after power verification.

2) Input RF Signal Range: Optimal input RSSI into the repeater is -55dBm ~ -25dBm for

800MHz. User should verify input condition of Donor ANT. If the input RSSI exceeds -20dBm,

then external attenuators should be used.

3) Isolation check between DONOR/SERVER ANT: Isolation condition of this equipment is

87dBc (Gain+7dB) for 800MHz. User should check its condition before installation.