User's Manual

Sprint User Manual
3G Indoor Repeater
21
/
23
DL over-input alarm
Please Check following status;
-Proper maximum output power limit level
-BTS input level (Spectrum Level)
-Input RSSI value on Status Page
-Downlink Attenuation level
Please reset Adapter upon completing Alarm
troubleshooting
DL over-output alarm
-Make sure output power is operating normally
-Reset Adapter upon completing Alarm
troubleshooting
UL over-output alarm
-Please make sure output level is operating normally
-Please reset Adapter upon completing Alarm
troubleshooting
Temperature alarm
Check following status;
-Setting level of maximum temperature limit
-Temperature offset is normal or not
-Circumstances of temperature
Reset Adapter upon completing Alarm
troubleshooting
When in
alarming
RF off
-Verify that the HPA’s are On
-Reset Adapter upon completing Alarm
troubleshooting
Technician should verify
category of alarm at the
front side of repeater
-When Red light on the Shutdown LED, technician
should troubleshoot the alarm via Notebook
computer
-Technician should
connect antenna with
output port of repeater
-Please make sure all
connectors are fastened
-Reconnect the connector
-Change it if the connector is defective
When output
power is no
longer
problem
Check the input level
-Increase output power or check input change of
BTS side