Operation Manual

ENGLISH
16
SETTINGS
---------------------------------------------------------------------------------------------------------------------------------------
5 Select the input source from which the au-
tomatic time synchronisation should be per-
formed.
Selection options:
– »Update from DAB«;
– »Update from FM«;
– »Update from Network« (Time synchronisa-
tion from an Internet station),
– »No update« (no automatic time synchro-
nisation).
Select one of the options with » « or » «
and press »OK« to confirm.
– The menu »Set timezone« appears (only if
»Update from Network« was selected).
Note:
7
If »Update from FM« or »Update from
DAB« was selected, continue from point 8.
6 Select the time zone (ex. »UTC +00:00
Dublin, London«) with » « or » « and press
»OK« to confirm.
– Display: »Daylight savings« menu opens.
Daylight savings
ON
OFF
*
Daylight savings
7 Select Daylight savings (for Central Europe)
with » « or » « to select »ON« and press
»OK« to confirm.
Normal time is set using »OFF«.
– The menu »Network settings« appears.
Network settings.
YES
NO
*
Keep network connected?
8 If the device is to be switched on via the net-
work, select the »YES« button with » « or »
« and confirm with »OK«.
If the device is not to be switched on (low
stand-by power), select the »NO« button with
» « or » « and confirm with »OK«.
– The menu »Wlan region« appears.
Wlan region
Most of Europa
9 Select one of the WLAN regions with » « or
» « and press »OK« to confirm.
(This setting depends on the location where
you are operating your Sonoclock.)
– The »SSID« menu appears, and the availa-
ble networks (access points) are displayed.
Time/Date
SSID
[WPS]gimdsl
TCC-WLAN
grinternet
[Rescan]
[Wired]
Notes:
7
If you wish to connect via a LAN cable,
select the option »[Wired]« with » « or
» « and press »OK« to confirm.
The initial set-up is then finished.
7
If the connection to the router is via a
WLAN, there are two options, depending
on the router in use: If the router supports
[WPS], then continue operation from step
10/11 or step. 10/12.
If the router does not support [WPS], then
continue operation from step 13.