Operation Manual

13
ENGLISH
CONNECTION AND PREPARATION
---------------------------------------
Connecting the power cord
Note:
7
Check that the mains voltage on the type
plate (on the back of the device) corre-
sponds to your local mains supply. If this is
not the case, contact your specialist dealer.
7
Before connecting the power plug to the
wall socket, ensure that all other connec-
tions have been made.
1 Plug the power plug into the wall socket.
Caution:
7
The device is connected to the mains with
the power cord. Pull out the power plug
when you want to completely disconnect
the device from the mains.
Inserting battery in the remote
control
1 Pull off the film from the battery.
2 Take off the battery compartment cover
(screw cap).
3 When inserting the battery (3 V, lithium, CR
2025), make sure the positive terminal (+)
is facing upwards and the buttons on the
remote control are facing downwards.
4 Replace the battery compartment cover
(screw cap) and fasten it.
Notes:
7
Do not expose the battery to extreme heat,
caused for example by direct sunlight,
heaters or fire.
7
If the device no longer reacts properly to
remote control commands, the battery may
be flat. Always remove used batteries. The
manufacturer accepts no liability for dam-
age caused by leaking batteries.
Environmental note:
7
Batteries, including those which contain
no heavy metal, should not be disposed
of with household waste. Always dispose
of used batteries in accordance with local
environmental regulations.
•
OPEN
•
•
LOCK