Operation Manual

11
ENGLISH
OPERATION ______________________________
8 Let the appliance cool down in a location that
is safely out of reach of children.
Filling in the water tank
1 Grab the handle
G
and pull the water tank
N
out of the steam iron.
2 Open the lid of the water filling opening
J
and fill the water tank
N
with tap water or dis-
tilled water up to the MAX marking. The maxi-
mum capacity is 1.7 litres.
3 Close the lid of the water filling opening
J
and push the water tank
N
completely into the
steam iron station
C
. Make sure that it clicks
into place properly and is secured to the hous-
ing of the steam iron station
C
.
Caution
7
Do not move or shake the steam iron station
C
when the water tank
N
is being filled. Water
might spill out from the opening of the water
tank
J
.
4 Press the steam button
I
briefly to reset the
iron. After about 2-3 minutes the iron will be
ready for steam ironing.
Notes
7
When the water tank
N
is empty, air enters
into the pump causing a louder ‘pumping’
sound. This is quite normal.
7
If your tap water is very hard it is recom-
mended to mix the tap water with distilled
water on a 50:50 ratio.
Steam ironing
1 Place the appliance on an even, dry and non-
slip surface. The non-slip feet
W
ensure the
stability of the appliance.
2 Fill the water tank
N
as described in the sec-
tion “Filling in the water tank”.
3 Insert the power plug
B
into the wall socket.
4 Push the On/Off switch
U
to switch on the
steam iron station
C
.
– The power indicator
O
lights up and the
steam indicator light blinks on LOW
T
.
5 Adjust the temperature control dial
K
to the
desired temperature.
– The temperature indicator light
E
lights
up blue. The temperature indicator light
E
remains on while the iron is heating up. As
soon as the iron reaches the set temperature,
the temperature indicator light
E
goes off.
The temperature indicator light
E
will go on
and off during usage to indicate that the set
temperature is being regulated.
Note
7
Steam ironing is only possible at higher tem-
perature settings marked with .
6 The water in the water tank
N
heats up within
2-3 minutes. As soon as the temperature indica-
tor light
E
goes off and the control indicator in
the steam setting remains lit, the steam iron is
ready to use. Place the iron in horizontal posi-
tion on the garments and press the steam but-
ton
I
. Continue to move the iron when ironing.
Caution
7
Never direct the steam at people or pets.
Notes
7
When the steam iron station
C
is switched on it
will produce a 'pumping' sound. This is normal
and indicates that water is being pumped from
the water tank
N
into the steam iron station
C
.
7 Select a higher steam level with the steam but-
tons “+” or ”-”.
– The corresponding control indicator blinks
as soon as it is selected. After approx. 2-3
minutes the control indicator will remain lit,
indicating that the appliance is ready for
steam ironing.
8 When there is insufficient water left in the water
tank
N
the steam generation stops and the
water filling indicator
Q
lights up, followed by
an audible beep. The control indicator in the
selected steam setting goes off. Place the iron
onto the storage base
L
and refill the water
tank
N
(see section “Filling in the water tank”).
9 After iron process is complete, place the iron
onto the storage base
L
.