STEAM IRON STATION SIS 8250 DE EN
______________________________________________ I H J G K F E D C L M B A N O power P Q R S T U V W X Y 3
SAFETY_ _____________________________________ Please read this instruction manual thoroughly prior to using this appliance! Follow all safety instructions in order to avoid damages due to improper use! Keep the instruction manual for future reference. Should this appliance be given to a third party, then this instruction manual must also be handed over. 77 77 77 77 77 77 77 77 Use this appliance for its intended purpose. Use this appliance indoors only. Do not use it in the bathroom or outside.
SAFETY ______________________________________ 77 77 77 77 77 77 77 77 77 77 77 77 77 77 Do not use this appliance with an extension cord. 77 Do not submerge the appliance, the power cable or the power plug in water or in any other liquid. Only clean this device with a slightly damp cloth. Always keep hair, clothing and other objects away from the appliance while it is in use in order to prevent injury and damages. Warning - Danger of Burns! Do not touch the hot soleplate.
OVERVIEW_ __________________________________ Dear customer, Control and parts Congratulations on the purchase of your new GRUNDIG Steam Ironing Station SIS 8250. See the figure on page 3. Please read the following user notes carefully to ensure full enjoyment of your quality GRUNDIG product for many years to come.
OPERATION__________________________________ Preparation 1 Remove all packaging materials, labels and protective foil and dispose of them according to the applicable legal regulations. 5 Depending on the type of fabric, turn the temperature control dial G to one of the following settings: 2 Clean the outer parts of the appliance as described in the section “Cleaning and care“. 3 Place the appliance on an even, stable, dry and non-slip surface. 4 Place the iron onto the storage base E .
OPERATION__________________________________ 7 After the ironing process is complete, place the iron onto the storage base. 8 Press and hold down the on/off switch of the steam ironing station for a few seconds to switch the steam ironing station off. Set the temperature control dial to MIN and disconnect the plug from the power outlet. – The red power indicator light N and the blue steam button indicator light LOW P go off.
OPERATION__________________________________ 7 Select a higher steam level with the steam buttons MEDIUM Q or HIGH R . – The corresponding control indicator in the steam button blinks as soon as it is selected. After approx. 2 minutes the control indicator will remain lit, indicating that the appliance is ready for steam ironing. 8 When there is insufficient water left in the water tank C the steam generation stops and the water filling indicator O lights up, followed by an audible beep.
INFORMATION_______________________________ Tips for ironing Cleaning and care Prior to ironing, always check the garment label to ensure the correct tempearture is set on the iron. 77 Since the iron heats up much quicker than it cools down, synthetic textiles, silk or similar fabrics should be ironed using lower temperature settings first. 77 If the garment is made of combined types of fabric, always begin with the lowest temperature setting first.
INFORMATION_______________________________ Descaling Note 77 To maintain efficiency and extend the operating life of your steam ironing station and to avoid scale particles on your garments, this unit is equipped with a "Descaling" warning indicator light T . This light flashes on the control panel L after about 100 minutes of operating time. 77 When the descaling indicator T lights up, you can continue using your iron normally but you need to remember to descale the unit before using it the next time.
INFORMATION_______________________________ Environmental note Technical data This product is manufactured from high-quality parts and materials which can be reused and recycled. Therefore, do not dispose the product with normal household waste at the end of its service life. Take it to a collection point for the recycling of electrical and electronic equipment. This is indicated by this symbol on the product, in the operating manual and on the packaging.
www.grundig.
