STEAM STATION SIS 7040 de Product code 1806802 en
SAFETY AND SET-UP________________________ Please read this instruction manual thoroughly before using this appliance. Follow all the safety instructions to avoid damage caused by improper use. Keep this instruction manual for future reference. Should this appliance be given to a third party, then the instruction manual must also be handed over. Use this appliance for its intended purpose. Only use this appliance indoors. Do not use this appliance in the bathroom or outside.
SAFETY AND SET-UP________________________ Always keep hair, clothing and other objects away from the appliance while it is in use in order to prevent injury and damages. Warning - Danger of Burns! Do not touch the hot soleplate. Do not lean over the iron while it is in use. Heat will rise from the device during usage! Only touch the iron by the handle. Only use the iron with the connected steam ironing station.
AT A GLANCE_______________________________ Dear customer, Control and parts We congratulate you on the purchase of your steam ironing station SIS 7040. See the figure on page 3. A Cable storage holder with clamping bracket B Power cable with power plug C Removable water tank D Soleplate Special features E Thermally insulated storage base The Grundig steam ironing station is equipped with a 1.
OPERATION________________________________ Preparation 1 Remove all packaging material, stickers and protective foil and dispose of them according to the applicable statutory regulations. 2 Clean the outer parts of the appliance as described in the section “Cleaning and Care“. 3 Place the appliance on an even, stable, dry and non-slip surface. 4 Place the iron on the surface of the storage base E .
OPERATION________________________________ - The red power indicator light N and the blue steam button indicator light LOW P go out. 8 4 - The power indicator N lights up red and the blue steam button indicator light blinks on LOW P . Let the appliance cool down in a location that is safely out of reach of children. 5 Filling of the water tank The water tank can be refilled at any time during use. Pull the water tank out of the steam iron. To do this, grab the handle V underneath the water tank.
operATION________________________________ 8 9 When there is insufficient water left in the water tank C the steam generation stops and the water filling indicator O lights up, followed by an audible beep. The control indicator in the selected steam button goes off. Place the iron on the surface of the storage base and refill the water tank (see section Filling of the water tank). After ironing, place the iron on the surface of the storage base.
INFORMATION_____________________________ Tips for Ironing Prior to ironing, always check the garment label to ensure the correct temperature setting is on the iron. Since the iron heats up much quicker than it cools down, synthetic textiles, silk or similar fabrics should be ironed using lower temperature settings first. Never clean the soleplate with chemicals, steel wool, wood or other abrasive cleaning agents.
INFORMATION_____________________________ Note Instead of using the key provided, you can also use a flat head screwdriver or a coin. 4 Let the water drain out into a sink. 5 Screw in the water drainage screw again and tighten it. 6 Push the rubber closure onto the water drainage screw. Environmental note This product has been manufactured with highquality parts and materials which can be reused and are suitable for recycling.
www.grundig.
