EPILATOR WITH INTERCHANGEABLE SHAVING HEAD LE 8820 ENGLISH
_________________________________________________________ A B C D E F G H I J 2
SAFETY _____________________________________________ Please note the following instructions when using the appliance: 7 7 7 7 7 This appliance is designed for domestic use. This device is only for the purposes outlined in this operating manual. Only operate the appliance with the mains cable set (CTR06-0900400G) supplied. Never use the appliance in the bath, shower or over a wash basin filled with water; nor should it be operated with wet hands. Do not drop the appliance.
OVERVIEW ________________________________________ Special features Your device is suitable for any type of hair. The patented innovative rotating head removes even the shortest of hairs of 0.5 mm or more. Controls and packing contents See the illustrations on page 2. A Protective cap. B Rotating head. The device will remove your hair right down to the root for four to six weeks. C Rotating head housing. D To prepare for epilation, you can trim longer hairs with the interchangeable shaving head.
POWER SUPPLY __________________________________ Check if the mains voltage on the type plate of the power supply unit supplied corresponds to your local mains supply. The only way to disconnect the device from the mains is to unplug the power supply unit. 1 Plug the power supply unit into the F socket. 2 Plug the power supply unit into the wall socket.
OPERATION _______________________________________ Trimming/shaving hairs If you wish to epilate hairs which are longer than 10 mm, it is advisable to trim these with the shaving head beforehand. Caution 7 The shaving head can only be used with speed setting 1. 1 Turn the appliance off and unplug the cable. Pull the power supply unit out of the mains socket. 2 Remove the rotating head. To do this, press the side catches D and take off the rotating head with the other hand.
OPERATION _______________________________________ 1 Remove the protective cap A from the device. 2 Press the E button to switch off the device. 4 Hold the appliance in your hand at a 100° angle to your skin. Do not exert any pressure, just touch the skin. 3 Adjust the speed. – Slow for fine hairs. – Fast for stronger hairs. 100° 5 Use short, circular movements as if you were brushing or wiping – in the direction the hair grows. Warning 7 Do not use the appliance on moles or birthmarks.
OPERATION _______________________________________ 6 Pull the skin taut with your other hand, if necessary. Stretch out your leg when removing hair behind your knee. 9 Hold out your arm to stretch the skin when removing armpit hairs. Note If you have not removed the hairs from your bikini area or under your armpits for a longer period, start by trimming them with the exchangeable shaving head G . 7 10 Press the E button to switch off the device after use.
OPERATION _______________________________________ Useful tips 7 7 7 7 The first time you use the appliance, it may feel slightly unpleasant, as you are removing hairs by the roots. This feeling subsides after several uses, even if you have sensitive skin. 7 7 If you have varicose veins or other health problems, you must consult your doctor before use. For reasons of hygiene, the appliance may only be used by one person. The first time you use the epilator, the results will last four to six weeks.
CLEANING AND CARE _________________________ Cleaning and care 1 Turn the appliance off and unplug the cable. Pull the power supply unit out of the mains socket. 4 Use the brush supplied J to remove all hairs from the mechanism, the housing and the appliance. 2 Remove the rotating head. To do this, press the side catches D and take off the rotating head with the other hand. 5 Replace first the housing, and then the rotating head. Push down the rotating head until it catches.
CLEANING AND CARE _________________________ Caution 7 Never hold the appliance in water or any other liquid. 7 Do not use cleaning agents. Clean the shaving head 1 Turn the appliance off and unplug the cable. Pull the power supply unit out of the mains socket. 2 Remove the shaving head. To do this, press the side catches D and take off the shaving head together with the housing. 3 Knock the bottom of the shaving head gently against a flat surface.
CLEANING AND CARE _________________________ Storage 4 Clean the bottom of the shaving head with the cleaning brush supplied J . If you do not want to use the appliance for a long period of time, please store it carefully. 5 Put the shaving head back on again. Push down the shaving head until it catches. 1 Ensure that it is switched off and is dry. 2 Store the appliance in its bag in a cool, dry place. 3 Make sure the appliance is kept out of reach of children.
INFORMATION ___________________________________ Environmental note This product has been made from high-quality parts and materials which can be re-used and recycled. Therefore, do not throw the product away with normal household waste at the end of its service life. Take it to a collection point for recycling electrical and electronic devices. This is indicated by this symbol on the product, in the operating manual and on the packaging.
