Operation Manual

11.2. Cruise Programming

The network Speed Dome Camera supports up to eight Cruise Paths. Please follow the instructions below for

Cruise Path setup.

Cruise Setting :

To set up a Cruise Path, please first select a path number from the drop-down list. Then move the cursor to the

live view pane, and move the camera to a desired view (PTZ controls) as the start point of a Cruise Path. Press the

“Set” button of “Record Start” and start programming the Cruise Path via PTZ controls. When finishing

programming, press the “Set” button of “Record End” to quit. Then this Cruise Path will be automatically

recorded.

Cruise Run :

Select the specified Cruise Path from the drop-down list, press the “Run” button, and then the camera will start

touring around as recorded.

To view the camera touring around in full screen mode, please move the cursor onto the live view pane, right-

click and left-click to select “full screen”. Then users can view the camera navigation in full screen.

To stop a running Cruise Path, simply move the cursor to the live view pane and move the camera in any direction.

English