Operation Manual

- Upload Image by FTP:
Select this item, and the Administrator can assign a FTP site and configure various parameters as shown in the
picture below. When a motion is detected, event images will be uploaded to the appointed FTP site.
- Upload Image by E-Mail:
Select this item, and the Administrator can assign an e-mail address and configure various parameters as shown
in the picture below. When a motion is detected, event images will be sent to the appointed e-mail address.
- Send HTTP notification:
Check this item, select the destination HTTP address, and specify the parameters for event notifications when
<Motion Detection> is triggered. When an alarm is triggered, the notification can be sent to the specified HTTP
server.
NOTE: Make sure SMTP or FTP configuration has been completed. See section 9.5. Mail and 9.6. FTP for further
details.
File Name :
The uploaded image’s filename format can be set in this section. Please select the one that meets your
requirements.
Save :
Click the "Save" button to save all the Motion Detection alarm settings mentioned above.
9.9. Storage Management
Users can store local recordings on a Micro SD/SDHC card up to 16GB. This page shows the capacity information
of the Micro SD card and a recording list with all the recording files saved on the memory card. Users can also
format the SD card and implement automatic recording cleanup through the setting page.
To implement Micro SD card recording, please go to the “Recording” page (see 9.10. Recording) for activation.
32
English